IMAGE 42 /62 - SEAL Graphics

More documents

Recommendations

Info

Cleaning & MaintenanceCleaningDo not use an abrasive cleaner on any surface. It may damage the surface ofthe silicone surface of the rollers or the paint work. Only use a damp cloth. Donot let water get onto the panels of the laminator as they are not sealed. Watermay enter the electrical circuits and cause injury to persons or damage to theequipment when power is applied.1. External SurfacesClean the external surfaces of the laminator with a damp cloth. If necessary, use householddetergent to remove difficult stains.2. CleaningUse an Image Roller Cleaner to remove excess adhesive. This should be done with therollers hot. When cleaning the top roller, place a scrap piece of board under the top roller toreduce waste adhesive falling onto bottom roller.Cleaning the Upper Roller38
Cleaning & MaintenanceEnCleaning the Lower RollerFor more thorough cleaning allow rollers to cool and then use isopropyl alcohol. This is bestdone using a clean, lint free cloth. Do not spill IsoPropylAlcohol (IPA) on the laminator.When using IPA, the rollers must be cold. IPA is inflammable. The flash point ofIPA (isopropanol) is 11°C (51.8°F). The self-ignition temperature is 400°C(752°F).NOTE: The rollers should be cleaned every day or the adhesive will build up and mayeventually damage the rollers.To clean the pull rollers use a clean, lint-free cloth moistened with water and householddetergent.MaintenanceThe Image <strong>42</strong> plus /<strong>62</strong> plus requires little maintenance, only the following are necessary:-1. Wipe the in-feed table with a dry cloth as necessary.2. Clean the rubber blocking cords on the unwind shafts as necessary.If a rubber blocking cord on the unwind shaft becomes too slack after a longer period oftime, unscrew one of the clamps, cut off 1 cm (0.5”) of the cord, and fasten it again using theclamp.For technical assistance, please contact your distributor.39
Page 1 and 2: IMAGE 42 Plus /62 PlusEnglishFranç
Page 3: IMAGE 42 Plus /62 PlusEnglishUser m
Page 6 and 7: IllustrationsSubjectPageFeatures an
Page 8 and 9: Features and Benefits of the Image
Page 10 and 11: Safety InformationThe IMAGE 42 plus
Page 12 and 13: Safety Features• If the machine i
Page 14 and 15: General Information• Power Source
Page 16 and 17: Uncrating and Moving The Image 42 p
Page 18: Connection to the Electrical Supply
Page 22 and 23: Control PanelThe laminator’s cont
Page 24 and 25: Control Panel☞Changingfrom normal
Page 26 and 27: WebbingSpecific webbing instruction
Page 28 and 29: Roller Nip SettingsWhenever you mou
Page 30 and 31: Laminating and Adhesive Coating (De
Page 32 and 33: Laminating and Adhesive Coating (De
Page 34 and 35: MountingStep 7 - When the end of th
Page 36 and 37: EncapsulatingStep 1b - Linered film
Page 38 and 39: Pre-CoatingThis process is used to
Page 42 and 43: TroubleshootingProblem: The machine
Page 44: AccessoriesThe following accessorie

IMAGE 42 /62 - SEAL Graphics

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?