GPR-1800 AIS ATEX Trace PPM Oxygen Analyzer - Advanced ...

Advanced Instruments Inc.MAIN MENUAUTO SAMPLEMANUAL SAMPLECALIBRATIONCONFIG ALARMSBYPASS ALARMS>>>CALIBRATIONSPAN CALIBRATEZERO CALIBRATEDEFAULT SPANDEFAULT ZEROOUTPUT SPANOUTPUT ZERO5. Advance the reverse shade cursor using the ARROW keys to highlight OUTPUT SPAN.6. Press the ENTER key to select the highlighted menu option.7. The following display appears:100.0OUTPUT SPAN OFFSETPRESS UP OR DOWNTO CHANGE VALUEENTER TO SAVEMENU TO RETURN8. Enter the adjustment value as follows . . .9. Selecting digits of the adjustment value to change - Press the ENTER key to advance the underline cursor right or pressthe MENU key to advance the underline cursor left to reach to the desired digit.10. Changing the digits of the adjustment value . . . Press the UP/DOWN ARROW keys to change a digit of the adjustmentvalue.11. Repeat steps 9 and 10 until the complete span value has been entered and the following display appears.064.0OUTPUT SPAN OFFSETPRESS UP OR DOWNTO CHANGE VALUEENTER TO SAVEMENU TO RETURN12. Save the adjustment value by pressing the ENTER key or abort by pressing the MENU key.13. The system returns to the SAMPLING mode.14. Note: After the initial adjustment is made, check the actual signal output at the PLC and if necessary calculate a furtherfine tuning adjustment value as illustrated above.15. Enter subsequent fine tuning adjustments as described above.075.0OUTPUT SPAN OFFSETPRESS UP OR DOWNTO CHANGE VALUEENTER TO SAVEMENU TO RETURN16. Save the adjustment value by pressing the ENTER key or abort by pressing the MENU key.17. The system returns to the SAMPLING mode.41