2200 Enteral Feeding Pump

Operating Instructions (Cont’d)9. Remove protective cover from barbed adapter.10.To prime set by gravity, open roller clamp, if soequipped, or grasp the in-line occluder by thebase and tilt approximately 45 degrees to theright or left, while gently pulling down. Hold thisposition until air is expelled from the tube. Ifneeded, gently squeeze bag at the same time tostart fluid flow. Close roller clamp when prime iscomplete, if so equipped.Note: Do not fill the drip chamber above the fill line.11.Carefully stretch silicone tubing around pumprotor and fully seat in-line occluder or retainerinto the bracket. Pull tubing into tubing guideand through the side retention clip. Close clipwith tubing in place.12. Attach set to feeding tube.13. To set dose limit, pressDOSE LIMIT SET and thenpress INC or DEC.If dose limit is not used,pump will run until containeris empty orpump is turned off.14. Open delivery set rollerclamp, if so equipped.Press tubing into tubingguide slot.Insert and fully seat inlineoccluder flange intopump bracket.10