download assembly guidelines - Ashford Handicrafts

More documents

Recommendations

Info

Insert the polyurethaneconrod joints into theend of the conrods.Place the wheel in positionand insert the crank shaft.Align the hole in the crankshaft with the groove ofthe hub. Check the wheelis parallel in the centre ofthe base and the wheelsupports are tight againstthe hub. If not, loosen thebolts, adjust the wheelsupports and retighten.
Rotate the hub pin untilit is a firm fit in the slotin the hub. Then tap thehub pin through the huband crank.Hint: Use a Lazy Katepin as a punch to avoiddamaging the hub.Slide the inner shell of the conroduniversal joint onto the crank until itclicks into the groove. Then click thefront conrod onto the universal jointon the crank.
Page 1 and 2: INSTRUCTIONSTRAVELLER SPINNING WHEE
Page 3 and 4: Traveller Single Drive Spinning Whe
Page 5 and 6: Check the angle of nylon bearingsan
Page 7 and 8: Locate the treadle rail into thehol
Page 9: Check the alignment ofthe holes for
Page 14 and 15: Tie the threadinghook to the frontm
Page 18: Ashford Handicrafts Ltd.Factory and

download assembly guidelines - Ashford Handicrafts

Create successful ePaper yourself

Delete template?

Save as template?