download assembly guidelines - Ashford Handicrafts

More documents

Recommendations

Info

Thread 12 hooks into the flyer.Secure the 2 hinges tothe maiden bar.Note the position ofthe slot in the hinge.Assemble the flyer unit.Check the shape of thenylon bearing on eachmaid upright, then insertinto the correct hole.Insert the drive beltadjusting knob into themaiden bar, turn until theend just protrudes.
Check the angle of nylon bearingsand then secure the maid uprightswith screws and washers. Do not overtighten. The maid uprights may betwisted to remove the bobbin. Thread the screw eye into the side of the maiden bar.Slide a bobbin onto the flyer and the flyerinto the bearings. Thread the screw hookinto the opposite side.Attach the brake band.Thread it through thescrew eye and then tiethe springs as illustrated.
Page 1 and 2: INSTRUCTIONSTRAVELLER SPINNING WHEE
Page 3: Traveller Single Drive Spinning Whe
Page 7 and 8: Locate the treadle rail into thehol
Page 9 and 10: Check the alignment ofthe holes for
Page 11: Rotate the hub pin untilit is a fir
Page 14 and 15: Tie the threadinghook to the frontm
Page 18: Ashford Handicrafts Ltd.Factory and

download assembly guidelines - Ashford Handicrafts

Create successful ePaper yourself

Delete template?

Save as template?