GFK-210 Blower System - Heatilator Fireplaces

More documents

Recommendations

Info

NOTE: IF ANY OF THE ORIGINALWIRE AS SUPPLIED WITH THEAPPLIANCE MUST BE REPLACED,IT MUST BE REPLACED WITHTYPE 105 0 C RATED WIRE.BLOWERDETAIL APOWER CORDPLUG120V EXISTINGOUTLETDETAIL ABRNBLACKREDBLOWERCORDTO VALVE BRACKET(GROUND)GRNTEMPERATURESENSORSWITCHORGTO VALVEVARIABLESPEEDCONTROL(RHEOSTAT)CONTROLPANELZIP TIESPLUG INTO 120VEXISTING OUTLETPOWERCORDVARIABLE SPEEDCONTROLDC REGULATORRECEPTACLEBLKBLKBLKWHTBLKTEMPERATURESENSOR SWITCHBLKBLOWERRECEPTACLEBLOWERCORDGRNBLKGRNBLKBLOWERSBLKBLKGRNWHTGRNBLKFigure 6. Fan Wiring Diagram - Metal Insert Without RC200/RC3004 Hearth & Home Technologies • GFK-210 Blower System Instructions 2206-938 Rev. H • 7/11
9.0 Fan Wiring with RemoteThis appliance may be used with an RC200 or RC300remote control. See Figure 7.1. Remove cord assembly spades from rheostat andsensor switch.NOTICE: Fan speed and operation are controlled by theremote control. The sensor switch and rheostat are nolonger needed.2. Plug two cord assembly spade connectors together.3. Unplug fan cord assembly from standard cord assembly.4. Install fuse wire assembly in series between the blacklead wires of the fan cord and black lead wire on eachblower. See Figure 7.5. Plug fan cord assembly into AUX300 module.6. Plug AUX300 module into the standard cord assembly.NOTE: IF ANY OF THE ORIGINALWIRE AS SUPPLIED WITH THEAPPLIANCE MUST BE REPLACED,IT MUST BE REPLACED WITH TYPE105 0 C RATED WIRE.BLOWERPLUG120V EXISTINGOUTLETSTEP 5NOTE: USE ZIP TIES TO RESTRAINTHE LOOSE WIRES UNDERNEATHTHE APPLIANCE AND KEEP THEMAWAY FROM THE BLOWER WHEEL(FAN BLADES).STEPS3 & 5STEPS1 & 2SENSOR SWITCHWHT (2)GRN (2)BLK (2)BLK (2)GRN (2)BLK (2)SPEED CONTROL(RHEOSTAT)NOTE: SENSOR SWITCH ANDRHEOSTAT SPEED CONTROL MUSTBE REMOVED FROM CIRCUIT IFSYSTEM IS CONTROLLED WITHRC200/300 REMOTE.PLUG INTO 120VEXISTING OUTLETBLKBLKDC REGULATORRECEPTICLETO CONTROLMODULEBLOWERRECEPTICLEAUX 300 MODULEFANWHTGRNBLKBLKGRNWHTFUSE WIREASSEMBLYFUSE WIREASSEMBLYBLKGRNBLKBLKGRNBLKBLOWERSFigure 7. Fan Wiring Diagram - Metal Insert with RC200/RC300 RemoteHearth & Home Technologies • GFK-210 Blower System Instructions 2206-938 Rev. H • 7/115
Page 1 and 2: GFK-210 Blower System- Installation
Page 3: 5.0 INSTALLING THE VARIABLE SPEEDCO
Page 7: Note: if any of the original wire a

GFK-210 Blower System - Heatilator Fireplaces

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?