HAUCK LONG NOSE STARJET BURNER LNSJ360 â LNSJ980

More documents

Recommendations

Info

15. High fire can be modified by increasing or decreasing fuel oil pressure or by changingthe maximum oil metering valve stroke. After changing fuel oil pressure, low fire shouldbe rechecked.16. Check rotation of the combustion blower. The impeller should rotate toward the blowerdischarge.17. Inspect and operate the plant exhaust damper control. The exhaust damper should becapable of maintaining a consistent negative pressure at the drum front bulkhead ofnegative 0.2 to negative 0.5 "wc (negative 5 to negative 13mm wc) from low to high firingrates for most applications.18. The low/high oil pressure switch is factory set at a low set point of 15 psig (103 kPa) anda high set point of 80 psig (552 kPa). Set point adjustments may be required dependingon the burner and fuel oil piping specifics.19. Burner flame spin vanes adjustment can be set at 0 to 60 degrees; 0 degrees narrowsthe flame, 60 degrees widens the flame, and 30 degrees is a nominal starting point.20. Burner air adjustments: (see Section P).21. Recheck all linkages for tightness.22. Install a gas sampling probe in the dryer drum rear (see Application Sheet GJ73).23. Connect a gas analyzer to the gas sampling probe (see Application Sheet GJ73).Exhaust gas readings should be taken at operating tonnage.Page 22LNSJ -9
Page 23LNSJ -9Y7513(NOT TO SCALE)Figure 13. Typical Schematic of Burner Heavy Fuel Oil Piping
Page 1 and 2: INSTRUCTIONSHAUCK LONG NOSE STARJET
Page 3 and 4: C. BURNER CAPACITIESRefer to burner
Page 5 and 6: D. DIMENSIONSPage 5LNSJ -9Y5373(NOT
Page 7 and 8: D. DIMENSIONS (Continued)Page 7LNSJ
Page 9 and 10: D. DIMENSIONS (Continued)Page 9LNSJ
Page 11 and 12: F. BURNER MOUNTINGPage 11LNSJ -9X53
Page 13 and 14: H. NATURAL GAS FUEL PIPING SYSTEMPa
Page 15 and 16: 5. The piping from the gas regulato
Page 17 and 18: I. LIGHT FUEL OIL PIPING SYSTEMPage
Page 19 and 20: 13. High fire oil flow can be adjus
Page 21: Page 21LNSJ -9NOTEHauck recommends
Page 25 and 26: Page 25LNSJ -9NOTE120V/60Hz power f
Page 27 and 28: Page 27LNSJ -9M. COMPRESSED AIR/OIL
Page 29 and 30: Page 29LNSJ -9COMPRESSED AIR/OIL AD
Page 32 and 33: N. LIQUID PROPANE (LP) FUEL PIPING
Page 34 and 35: Page 34LNSJ -9NOTELP manifold must
Page 36 and 37: Page 36LNSJ -9e. Adjust the backpre
Page 38 and 39: Page 38LNSJ -94. Remove the four bo
Page 40 and 41: Page 40LNSJ -9O. BURNER PILOT SYSTE
Page 42 and 43: Page 42LNSJ -93. The plant exhaust
Page 44 and 45: Table 8. Initial Burner Component S
Page 46 and 47: Page 46LNSJ -9Secondary Air Sleeve
Page 48 and 49: 5. Periodically check all safety eq
Page 50 and 51: Interpretation of Gas Readings.Page
Page 52: Page 4GJ73FEDRUM MIX PLANTTYPICAL S

HAUCK LONG NOSE STARJET BURNER LNSJ360 â LNSJ980

Create successful ePaper yourself

Delete template?

Save as template?

HAUCK LONG NOSE STARJET BURNER LNSJ360 â LNSJ980