HAUCK LONG NOSE STARJET BURNER LNSJ360 – LNSJ980

Page 25LNSJ -9NOTE120V/60Hz power for the heavy oil insert heatermust be supplied separately by the customerand wired into the heater junction box.Operation of the heavy oil insert kit is as follows (see Figure 15):1. Adjust the low temperature controller to the desired temperature as determined in Section Kfrom testing of the heavy oil viscosity.NOTEAdjusting the trip setpoint above the required temperature, asdetermined by fuel oil viscosity testing, may result in coking ofthe fuel oil in the insert oil piping.2. Energize the insert heater circuit breaker switch.3. When the oil temperature exceeds the setpoint on the oil temperature indicating controller, theoil temperature indicating controller switch contact will open and power to the heater elementis removed.4. When the oil temperature drops below the setpoint on the oil temperature indicating controller,the oil temperature indicating controller switch contact will close and the heater element willenergize.See SJ-9.2 StarJetHeavy Oil Insert Heater Kit Instructions for more specific detail on theoperation and maintenance of the heavy oil insert heater.