JANUS Engineering Training 0.4.pdf - Grostech.com

More documents

Recommendations

Info

Comms WiringComms Lines Outside• A 485/422 comms line is only ever grounded at ONE END between nodes• Each node on a segment must share a common building ground• If a common ground is not available then Galvanic Isolation should be employedbetween different earth potentials, otherwise comms problems may arise• If cables run externally, Lightning Arrestors should be installed where the cablesenter and exit the building. Galvanic Isolation should then be used between theLightning Arrestor and IDC• Underground cable runs do not require Lightning ArrestorsAlternatively use TCP/IP or Fibre272814
Install JANUS 4.3r1• Auto run the Install software from the USB Stick• Install the MAIN PC and select MAIN PC• Say yes to Graphics and No to windows account synchronisation.• Load the licence file from the LIC folder from the USB Device• Restart the PC• Plug in the Dongle• Run:• JANUS COMMS• JANUS DATABASE• JANUS REPORT SCREEN (SCROLL)•Get the MAC and Serial from your Board. Using the eSeries Programmer configure your LH-ENET-485 and IDCe•Test the connectionsEngineer Logon:username : INSTALLERpassword : JANUS•Get the IDC and IDCe Online313215
Page 1 and 2: Level 1 - Hardware
Page 3 and 4: Readers Wiegand or Clock & DataSwip
Page 5 and 6: Example Naming ConventionsLONDON Gr
Page 7 and 8: Intelligent Door Controller (IDC)
Page 9 and 10: Reader and Lock WiringIDC-485 Histo
Page 11 and 12: JANUS Enclosure ENC-20-PSU-230VSing
Page 16 and 17: JANUS Comms ProgramGREENMEENZCHOICE
Page 18 and 19: JANUS Comms ProgramCreating a Comms
Page 20 and 21: Ethernet Line HeaderIDCeIf No Site
Page 22 and 23: Box (Controller)IDC Card Capacity I
Page 24 and 25: DoorReaderName the doorChoose IDCTi
Page 26 and 27: CardsCardJANUS reads the whole card
Page 28 and 29: Janus Report ScrollWhere a card was
Page 30: Getting a Door Working1. JANUS DATA

JANUS Engineering Training 0.4.pdf - Grostech.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?