JANUS Engineering Training 0.4.pdf - Grostech.com

More documents

Recommendations

Info

JANUS Comms ProgramCreating a Comms LineNeed to be logged on;When a box is selectedand this button is pressedthe MP count will be resetand if the box is offlinecomms will immediatelypoll the box.• Local Comms Port: PhysicalPort attached to Server (1-9)• Network Comms Port:Software accessible CommsPort• Local Modem: Modem• Ethernet Comms Server:Ethernet Line Header (Nonencrypted)• eSeries: IDCe and encryptedline headersNo need to be loggedon; MP count for allboxes on line reset• Missed Polls indicate communicationsproblems; check cables/comms chips etc.• You would expect all the boxes on a line tohave roughly the same MP count.• A controller may affect the MP count ofother boxes on the line.Auxiliary Line Type: If because of a fault, acontroller cannot be contacted through theprimary route, another route canautomatically be initiated by the system.Two additional ports may be defined for anygiven Comms Line.Speed: Must match box speed.38Normally, fields in the Comms Line Record become available or remain greyed out depending uponchoices made. For example the Telephone Number field would only become available if Local Modem isselected as the Line Type. For clarity, the Comms Line Record shown here has all fields shown withoutbeing greyed out.3918
eSeries SetupEncrypted - eSeries must be seeded by dongle number for IDCe to come onlineUnencrypted - Ethernet Comms Server (LH-ENET) no seed requiredSite Codes – Used With Redundant Comms programsWindows Server – MUST be Logged in at CONSOLE (admin) level4019
Page 1 and 2: Level 1 - Hardware
Page 3 and 4: Readers Wiegand or Clock & DataSwip
Page 5 and 6: Example Naming ConventionsLONDON Gr
Page 7 and 8: Intelligent Door Controller (IDC)
Page 9 and 10: Reader and Lock WiringIDC-485 Histo
Page 11 and 12: JANUS Enclosure ENC-20-PSU-230VSing
Page 14 and 15: Comms WiringComms Lines Outside•
Page 16 and 17: JANUS Comms ProgramGREENMEENZCHOICE
Page 20 and 21: Ethernet Line HeaderIDCeIf No Site
Page 22 and 23: Box (Controller)IDC Card Capacity I
Page 24 and 25: DoorReaderName the doorChoose IDCTi
Page 26 and 27: CardsCardJANUS reads the whole card
Page 28 and 29: Janus Report ScrollWhere a card was
Page 30: Getting a Door Working1. JANUS DATA

JANUS Engineering Training 0.4.pdf - Grostech.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?