SERVICE MANUAL SERIES 165 - Precisa

Series 160Error messages10. Error messagesERROR-No. ERROR responsibility ERROR repair10.1 Operating error (Error disappears with correct use or application)ERROR 1 invalid program load right programERROR 3 weight too small use higher weightERROR 4 wrong anti-theft-code use right codeERROR 5 wrong anti-theft-code use right codeERROR 8zero point outside rangeERROR 9 / 0 calibration factor bad repeat calibrationERROR 9 / 1 zero point difference too high repeat calibrationERROR 9 / 2 difference of internal weight too high repeat calibrationERROR 9 / 3 calibration factor bad repeat calibrationERROR 30 no internal reference weight acknowledge with TARE-keyERROR 31 no external reference weight acknowledge with TARE-keyERROR 47 too much values use less valuesERROR 48 other unit then first value use the original unitERROR 49 too less values use more valuesERROR 53 values out of range +/- 50% use right weightERROR 60ERROR 61minimum transformer area fallen belowmaximum transformer area exceeded10.2 Fatal error (Balance stays still, error repair in service mode)ERROR 10 no linearisation values repeat linearisationERROR 11 no calibration factor repeat calibrationERROR 21ERROR 22ERROR 23no SCS temperature compensation valuesno temperature compensation valuesno SCS temperature no-linearity compensationvalues10.3 Hardware error (Balance stays still)ERROR 14 wrong model code call serviceERROR 16 internal RAM destroyed replace CPUERROR 17 external RAM destroyed replace RAMERROR 18 / 1 wrong program check sum load right program, replace FLASHERROR 18 / 2no approved program build in approvedbalanceload right programERROR 18 / 8 FLASH empty load right program, replace FLASHERROR 18 / 9 wrong controller check sum replace CPUERROR 19 wrong code figure load right code figureERROR 20 temperature measurement defective call servicePrecisa Gravimetrics AG Index b E12