ICD Freestyle Paintball Manual - Paintball Manuals

More documents

Recommendations

Info

Installing/Replacing the BatteryUsing the 5/64" allen wrench provided in your kit, remove the two 6-32 button head screws thathold the grip panel in place on the left side of the gun. Fold the panel back as shown to allowfree access to the battery compartment. Be careful not to pull the wires to the battery terminal tohard or to far out of the compartment, you may damage the connection of the wire harness.Damage done because of pulled wires in this manor is not covered under warranty. Snap thebattery into the battery clip and place the battery and clip into the battery compartment beingcareful not to pinch or crimp the wires. Place the grip panel back into place and replace the 6-32button head screws.
Field stripping/ General maintenanceField stripping cannot be done while the FreeStyle is pressurized. Remove the air system fromthe gun to be sure there is no air in the gun. Using a 1/8" allen wrench, remove the 10-32 buttonhead screw from the back of the body as shown in the first photo. Once the 10-32 button headscrew is removed then slide the rear body straight out the back of the gun as shown in the secondphoto. This will allow a straight view out thru the front of the gun.
Page 2 and 3: FreeStyle Instruction ManualTABLE O
Page 4 and 5: LIMITED WARRANTYIndian Creek Design
Page 6 and 7: 4OPERATIONRead the entire manual be
Page 8 and 9: Keep your finger out of the trigger
Page 10 and 11: - Put the barrel plug, sock or barr
Page 12 and 13: To decrease the pressure shown on t
Page 14 and 15: Ball Breakage Problems1. The ball b
Page 16 and 17: 14NOTES:
Page 20 and 21: Adjusting your RegulatorsYour High
Page 22 and 23: Cleaning your Ball Detention System
Page 24: Maintaining your ValveREMEMBER! The

ICD Freestyle Paintball Manual - Paintball Manuals

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?