ICD Freestyle Paintball Manual - Paintball Manuals

Maintaining the Low Pressure RegulatorRemoving the low pressure regulator cannot be done while the FreeStyle is pressurized. Removethe air system from the gun to be sure there is no air in the gun. Unscrew the entire low pressureregulator from the front of the marker, being careful not to drop or lose the internals from thefront of the regulator.The regulator must be cleaned and lubricated on a regular basis. Clean all parts and thenlubricate the regulator piston size -15 urethane o-ring with Dow 33 lithium grease. Using a q-tipand rubbing alcohol, clean the regulator seal and flip or replace it if there are any mars, scratches,or dents.Notice the regulator cup is inserted into the top of the regulator with the cup portion facing theregulator seal and the guide section facing the spring, with the spring inserted over the guide.Notice also the steel pin of the regulator piston faces the regulator cup. Improper assemblyand/or failure to assemble all parts within the regulator will result in improper function ofthe regulator. If you do not feel comfortable disassembling and reassembling the regulator,take your marker to an authorized technician or call (208) 468-0446. Improper reassemblyand damage created from it are not covered under warranty.The low pressure regulator must be re-adjusted after disassembly.