ICD Freestyle Paintball Manual - Paintball Manuals

More documents

Recommendations

Info

Cleaning your Ball Detention SystemVery carefully remove the eye cover on the side of your marker using a 3/32 wrench. Set the eyecover aside. You now have access to the PDS sensors and ball detents. The ball detent consistsof a spring and a semicircle delrin piece. Remove both and clean with q-tips and rubbingalcohol. Reinstall by inserting the semi-circle piece sphere down into the hole and placing thespring behind it. The PDS sensors may be cleaned if needed. Be careful not to pull or pinch anywires while cleaning or reinstalling the eye cover. Pulling and/or pinching your wires is notcovered under warranty.
Maintaining your ValveREMEMBER! The rear main body MAY NOT be removed from the back of the markerwhen the marker is pressurized! When the rear main body is removed the cylinder assemblybecomes visible, as shown in the far left picture. The black cylinder body may be unscrewedfrom the back receiver. The valve housing rests underneath, as shown in the second picture. Thewhite valve housing tip may be unscrewed to be cleaned or for o-ring replacement. The valvepin is screwed into the piston, and may be unscrewed for cleaning or o-ring replacement. Useonly URETHANE 90 o-rings for the piston, valve pin, and interior of the cylinder assembly.
Page 2 and 3: FreeStyle Instruction ManualTABLE O
Page 4 and 5: LIMITED WARRANTYIndian Creek Design
Page 6 and 7: 4OPERATIONRead the entire manual be
Page 8 and 9: Keep your finger out of the trigger
Page 10 and 11: - Put the barrel plug, sock or barr
Page 12 and 13: To decrease the pressure shown on t
Page 14 and 15: Ball Breakage Problems1. The ball b
Page 16 and 17: 14NOTES:
Page 18 and 19: Installing/Replacing the BatteryUsi
Page 20 and 21: Adjusting your RegulatorsYour High
Page 24: Maintaining your ValveREMEMBER! The

ICD Freestyle Paintball Manual - Paintball Manuals

Create successful ePaper yourself

Delete template?

Save as template?