Technical Manual - BoXXer R2C2 - 2011 - SRAM.com

More documents

Recommendations

Info

BoXXer R2C2 technical manuallower leg installation1. Spray the upper tubes with isopropyl alcohol andwipe with a clean rag.2. Clean and inspect the shaft bolts, nylon crushwashers, and crush washer retainers. Replaceany crush washers and crush washer retainers ifdamaged.You must clean dirty crush washers and replacedamaged crush washers. Dirty or damagedcrush washers can cause oil to leak from thefork.3. Apply a liberal amount of grease to the innersurfaces of the dust wiper and oil seal.4. Gently slide the lower leg assembly onto theupper tubes. Make sure that the damper sidegoes into the right lower leg, and the spring sidegoes into the left lower leg. Slide the uppertubes into the lower leg until you feel the springand damper shafts make contact with the insideof the legs, then pull the upper tubes back outa few centimeters to provide clearance for oillubrication installation.Make sure both dust seals slide onto the tubescorrectly without folding the seals’ lip.5. Invert the fork to about 45 degrees, with thefork legs pointing upward. Measure and inject/pour 10 mL of RockShox 15wt suspension oil intoboth sides of the lower leg through the shaft boltholes.6. Slowly slide each upper tube completely intothe lower leg until the shaft threads are visiblethrough the shaft bolt holes.Sliding the upper tubes and lower legstogether too quickly will cause oil to spray out ofthe shaft bolt holes.7. Check for oil in the shaft threads. If there is oilin this area, use the corner of a rag to clean anddry the threads.8. Thread the rebound damper and coil springshaft bolts into the threaded shaft ends,through the lower leg holes. Use a 5 mm hex totighten the spring shaft bolt to 7.3 N·m (65 in-lb).Use a 24 mm flat wrench to tighten the rebounddamper shaft bolt to 7.3 N·m (65 in-lb).345 67 818GEN.0000000003185 REV C
BoXXer R2C2 technical manuallower leg installation (continued)9. Install the ending stroke rebound adjusterknob, followed by the washer onto the reboundadjuster shaft.10. Apply a small amount of threadlock to therebound knob retaining bolt. Install thebeginning stroke rebound knob and retaining boltonto the rebound adjuster shaft. Use a 2 mm hexwrench to tighten the bolt to 0.6-1 N·m (5-9 in-lb).11. Spray isopropyl alcohol on entire fork and wipewith a clean rag.91019GEN.0000000003185 REV C
Page 1 and 2: 2011 Technical Manual
Page 3 and 4: Table of Contentsgetting started...
Page 5 and 6: BoXXer R2C2 technical manualGETting
Page 7 and 8: BoXXer R2C2 technical manualanatomy
Page 9 and 10: BoXXer R2C2 technical manualFORK re
Page 12 and 13: BoXXer R2C2 technical manualseal se
Page 14 and 15: BoXXer R2C2 technical manualcoil sp
Page 16 and 17: BoXXer R2C2 technical manualdamper
Page 20 and 21: BoXXer R2C2 technical manualFORK in
Page 22: www.sram.comworld headquarterssram,

Technical Manual - BoXXer R2C2 - 2011 - SRAM.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?