Technical Manual - BoXXer R2C2 - 2011 - SRAM.com

BoXXer R2C2 technical manualfork installation (continued)4. Use a 4 mm hex wrench to torque the four lowercrown bolts in an alternating fashion to5 N·m (44 in-lb). Tighten the two upper crown boltsto 5 N·m (44 in-lb).5. Re-install the brake according to the brakemanufacturer’s instructions. Fasten the brake hoseto the brake hose guides on the fork’s lower leg.6. Position your wheel in the lower leg dropouts. Thehub should seat firmly in the dropouts. Be sure toposition the disc brake rotor in the caliper. Verifythat neither the rotor, hub, nor rotor bolts interferewith the lower legs. If you are unfamiliar withadjusting your disc brakes, see your brakemanufacturer’s instructions.7. Slide the externally threaded end of the Maxle DHthrough the drive side of the hub, until it engages thethreads of the lower leg dropout. Use a 6 mm hexwrench to turn the drive side axle bolt and tighten theaxle into the dropout. Torque to 5.7 N·m (50 in-lb).8. Use a 6 mm hex wrench to turn the non-drive sideaxle bolt clockwise until you hear or feel 8 clicks oryou reach a torque value of 3.4 N·m (30 in-lb).9. Re-check that all damping adjusters are at theiroriginal positions (documented in the table in the“Getting Started” section), or refer to theBoXXer R2C2 Tuning Guide to aid in tuningadjustments for the rider.47 8521GEN.0000000003185 REV C