Windows Setup Guide for ST-B10 - Toshiba Tec

More documents

Recommendations

Info

Windows Setup Guide for ST-B10TOSHIBA TEC CORPORATION EAA-03033When setting the “Set as primary”, the following window appears. Click on the “OK” button.When setting the “Set as primary”, the following window appears. Click on the “Yes” buttonwithin 15 seconds to save the setting.iii. Setting for display modes (Clone mode / Extend Desktop mode)To set for display modes, you must set LVDS display as Primary with reference to Section “ii.Setting for LVDS display as Primary”.‣ When setting Clone mode, go to the (a).‣ When setting Extended Desktop mode, go to the (b).33
Windows Setup Guide for ST-B10TOSHIBA TEC CORPORATION EAA-03033(a) Setting for Clone modeRight-click on the “S3” icon, the following menu appears. Click on the “Display PropertiesSettings” menu.The following window appears. Then, select the “Settings” tab. Click on the “2” (as indicatedwith the red circle), and uncheck “Extend my Windows desktop onto this monitor.” check box (asindicated with the blue circle). Click on the “Apply” button and the “OK” button.Note:If “Extend my Windows desktop onto this monitor.” check box is unchecked, the display isalready set Clone mode. Please click on the “OK” button.34
Page 1 and 2: Windows Setup Guide for ST-B10TOSHI
Page 35: Windows Setup Guide for ST-B10TOSHI

Windows Setup Guide for ST-B10 - Toshiba Tec

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?