Windows Setup Guide for ST-B10 - Toshiba Tec

More documents

Recommendations

Info

Windows Setup Guide for ST-B10TOSHIBA TEC CORPORATION EAA-03033The following calibration screen appears. Perform a calibration by touching the mark wheneverit appears. (The mark appears three times.)In display modes, how to calibration is difference. Please refer to the table as below.Remainder to use dual touch panelDisplay modesRemainder of CalibrationThe calibration screen appears on both panels two times. When youClone calibrate touch panels, sequence of calibration does not make anydifference.ExtendeddesktopThe calibration screen appears Primary display. After that, the screenappears Secondary display.63
Windows Setup Guide for ST-B10TOSHIBA TEC CORPORATION EAA-03033After the mark was touched three times, two buttons appear at the center of the screen. Click onthe check mark button to complete the calibration. After then, calibration screen re-appears.After complete the calibration to touch panels, open Device Manager to confirm the touch paneldriver has been installed one more. Make sure that double “Elo Serial Touchmonitor Interface” isregistered under the “Mice and other pointing devices” icon.64
Page 1 and 2:
Windows Setup Guide for ST-B10TOSHI
Page 3 and 4:
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16: Windows Setup Guide for ST-B10TOSHI
Page 65: Windows Setup Guide for ST-B10TOSHI
show all

Windows Setup Guide for ST-B10 - Toshiba Tec

Create successful ePaper yourself

Delete template?

Save as template?