NIBE F1330 - Klimats24.lv

Installation / AdjustmentDescription of functions - External controlDescription of functions - External controlElectrical connection, external control/blockingof the additional heat and compressor2X1LEK22F 1330 can be controlled up to a certain pointusing signals from an external system (e.g. DUC).All control signals must come from potential free relays.Activating/blocking compressor A (KPRAA)When the input (KPRAA) is made, the compressor will stopirrespective of the operating status and the operating type.When the operating type is set to External control in menu0.2.x, the compressor A will start with an open input andstop when the input is made. However, alarms and timeconditions in F1330 are superordinate to the external control.+EBV-cardConnection is made to terminals X4:1 and X4:2 on theEBV-card (2).Activating/blocking compressor B (KPRAB)Same function as above, but for compressor module B.Connection is made to terminals J5:1 and J5:2 on theMeasure card (22).+Measure cardJ5X4External Extra hot water activation (XVVA)If the input (XVVA) is made for at least one second, Extrahot water will be activated for 12 hours. See Descriptionof functions - Basic functions > Extra hot water for moreinformation.Connection is made to terminals X4:3 and X4:4 on theEBV-card (2).Tariff A (TA)Input (TA) can be used to select additional heat type (oilor electricity) if additional heat in menu 9.1.8 is selectedas ”El/Oil”. See ”Functions description- Basic functions” >”Electrical addition” and ”Function description- Basic functions”> ”Oil addition” for further descriptions.Connection is made to terminals X1:5 and X1:7 on theEBV-card (2).Tariff B (TB)When the input (TB) is made all electrical additional heatingis stopped. See Description of functions - Basic functions >Electrical additional heater for further details. Connection ismade to terminals X1:6 and X1:7 on the EBV-card (2).+EBV-cardThe heat pump in the picture is fitted with accessories.48 NIBE F1330