snazzi pushchair workshop manual - Tendercare Ltd

Snazzi Pushchair Workshop Manual7.1: Rear WheelsReplace if damaged or worn. To change the rear wheel:• Remove the wheel cap using a smallscrewdriver (see fig 7.1.1 left).• Using a 19mm spanner, undo the axlebolt and remove the wheel from theframe (see fig 7.1.2 below).Fig 7.1.1• Feed the M12 bolt throughthe wheel and apply someLoctite thread lockingcompound onto the protrudingthread, then screw the boltinto the threaded bush in theframe.• Tighten to 50Nm with atorque wrench.• Finally push fit the wheel capover the bolt head. Fig 7.1.2Document No: 055-05 v1b Page 12 of 29 August 2012Snazzi Pushchair Workshop Manual.docx