snazzi pushchair workshop manual - Tendercare Ltd

Snazzi Pushchair Workshop ManualPlace the slider and spring onto the framelocking point so that the slider is in the fully‘locked position’ (the frame hole will be atthe top of the slot in the slider, as shown inFig 7.5.6). Note that once the slider hasbeen removed the frame may close up alittle making it difficult to fit the new slider. Ifthis is the case, pull the front and rearframes towards each other and the slidershould drop down easily.Fig 7.5.6Next, take the M6 x 50mm socket button boltand place one of the form A washers onto itas shown (see Fig 7.5.7).Fig 7.5.7Place the hexagon key though the slot in theslider in-between the spring coils, and pullthe spring back down the slot so that thefixing hole is clear (see Fig 7.5.8). Pleasenote if it is not possible to pull the springback far enough, lift the slider off of theframe, rotate the spring a little and try again(rotating the spring will expose differentparts of the coil- rotate until a section of coilis visible that is close to the top of the slot,this will allow the spring to be compressedfar enough to clear the hole).Fig 7.5.8Document No: 055-05 v1b Page 19 of 29 August 2012Snazzi Pushchair Workshop Manual.docx