snazzi pushchair workshop manual - Tendercare Ltd

Snazzi Pushchair Workshop Manual7.2: Front CastorsReplace if damaged or worn. To change the front castor:• Remove the wheel by unscrewing theM8 socket cap bolt using a 5mmhexagon key.• Next remove the castor housing usinga 19mm spanner.Fig 7.2.1• To fit the new castor, firstensure the wheel is removedfrom its housing.• Next place the bolt through thehousing and apply some Loctitethread locking compound on theprotruding threads, then screwinto the threaded bushing in theframe and tighten to 50Nm witha torque wrench.• Screw the new wheel into thecastor housing using a 5mmhexagon key and tighten firmly(no other tool is required to fitthe wheel as the castor housingincludes a captive nylock nut).Fig 7.2.2Document No: 055-05 v1b Page 13 of 29 August 2012Snazzi Pushchair Workshop Manual.docx