The Performance Edge - Yamaha-Racingparts.com

More documents

Recommendations

Info

18. ECU Set (4C8-8591A-80)Parts ListNo. PART No. PART NAME Q'TY REMARKS1 4C8-8591A-80 ECU 12 13S-2818Y-70 CD 1 YMS, MANUAL• Use of this set and a wire harness included in the kit enables regulation (or setting) of fuelinjection and ignition timing, etc.• For details as to how to regulate (or set) fuel injection and ignition timings, etc., refer to theFI matching system manual in the CD-ROM that comes with the set.• There are two types of basic control data for the ECU included in this set: SB (Super Bike)and ST (Stock Sports). They can be switched over and vice versa. To make it in the STspecification, just remove two couplers located at the lower left of the kit harness fuel tank.(See the figure below.)SB specification: Kit cam shaft and *Recommended mufflerST specification: *Recommended muffler* Recommended mufflerMade by Akrapovic (For details of the specification, please access the website.)Web http://www.akrapovic-exhaust.comCAUTION:Do not use the ECU of this set for any other assembly than the one below.ECUWIRE HARNESS ASSY. THROTTLE BODY ASSY.2007 Models 4C8-8591A-70 4C8-82590-70 4C8-13750-002008 Models 4C8-8591A-80 4C8-82590-80 4C8-13750-20– 31 –
19. Cable Interface (13S-8533A-70)Parts ListNo. PART No. PART NAME Q'TY REMARKS1 13S-8533A-70 CABLE, INTERFACE 1 USB2 13S-N81CD-70 8cm CD 1 USB driver• This cable connects the kit wire harness to the personal computer on which YEC FIMatching System (YMS) is installed.• Please see the YMS manual for instructions on how to use YMS.• When connecting the cable to the PC for the first time, it is necessary to install the USBdriver. Refer to the USB Driver Installation Manual provided on the 8 cm CD for details onhow to install the USB driver.• The product vendor ID and product ID are provided by the Hamamatsu TOA Electronics,Inc.Vendor ID: 6837Product ID: 9001– 32 –
Page 2: Introduction• Please understand t
Page 5 and 6: 2 Kit Parts2-1 Engine Parts1. Maint
Page 7 and 8: 3. Head-gasket, Cylinder GasketPart
Page 9 and 10: 5. High-lift CamshaftsParts ListNo.
Page 11 and 12: 7. Funnel Set (4C8-A4460-80)Parts L
Page 13 and 14: 8. Throttle Body Clamp Set (4C8-135
Page 15 and 16: - 12 -
Page 17 and 18: 11. Slipper Clutch Setting Set (4C8
Page 19 and 20: When installing the kit parts, the
Page 21 and 22: Parts ListNo. PART No. PART NAME Q'
Page 23 and 24: YZF-R1 Mission ratioGEAR PLAN Ratio
Page 25 and 26: YZF-R1 Speed ListEngine speed (rpm)
Page 27 and 28: 38363329282928273032313028293534212
Page 29 and 30: 14. Gear, 5th Wheel Special (4C8-17
Page 31 and 32: 16. Sprocket Nut Set (4C8-A7463-70)
Page 33: NOTE:• The rotor and starter clut
Page 37 and 38: Self-Diagnosis Functions• The ECU
Page 39 and 40: • The switch installed to the STD
Page 41 and 42: 2-2 Chassis Parts22. Oil Catcher Ta
Page 43 and 44: 23. Front Fork Spring SetParts List
Page 45 and 46: 25. Front Spare Wheel ASS’Y (4C8-
Page 47 and 48: 27. Throttle Set (4C8-C6300-70)Part
Page 49 and 50: 29. Tube Guide (5VY-26243-80)Parts
Page 51 and 52: EngineTo be tightened Part No. Part
Page 59 and 60: ChassisTo be tightened Part No. Par
Page 61 and 62: Tightening the Cylinder HeadTighten
Page 63 and 64: 4 Headlight Cord Wiring Diagram- 60
Page 65: Published by YAMAHA MOTOR ENGINEERI

The Performance Edge - Yamaha-Racingparts.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?