AquaMatic Series A100 Stager Control - Pentair Residential Filtration

REGENERATION INITIATIONS OPTIONSSeries A100:Manual (internal):Automatic:Open enclosure. Depress RED BUTTONand turn pointer knob counterclockwiseto the START position (see Figure 2A100 Timer Faceplate).Preset day and time.TROUBLESHOOTINGProblemTimer andStager are outof sequence.Stager doesnot advanceautomatically.Solution• Check that the number of pins that are in the"UP" position on the timer pinwheel (Figure2 A100 Timer Faceplate), match EXACTLY thenumber of notches in the stager cam assembly• Make sure that there are no wires coming incontact with the pinwheel assembly.• Manually rotate the stager assembly to the"Service" position. Then, check the operation ofthe timer pinwheel assembly by depressing andthen releasing the micro-switch located on thepinwheel. You can repeat this for each step ofthe regeneration cycle to ensure that the stagerand timer are working properly.• Verify the connections of the "Homing" feature,(If Applicable, See Figure 3)• Manually rotate the stager assemblyapproximately 1/4 inch. The stager motorshould take over the operation and advance thestager to the next step. The "Homing" featurewill return the stager to the "Service" positionautomatically.• Verify that all wiring connections are madecorrectly. (See Figure 3)• Check that the correct voltage and frequencyare being used as specified for the control.5730 North Glen Park Road, Milwaukee, WI 53209Technical Support: 800.279-9404© 2010 Pentair Residential Filtration, LLC 1073947 Rev. C JA10