4040 - Methane / Nonmethane analyzer - Teledyne Analytical ...

More documents

Recommendations

Info

Installation Series 4040% of Range for THC (THC – Total Hydrocarbon is the summationof the CH4 and NMH values).Waveform. Waveform is the FID detection level updated 10 timeseach second. The output is compared against the maximuminput for the Analog to Digital Conversion hardware andscaled to a 0-1VDC (or 4-20mA DC) output.Note: The Range setting applies to the CH4, NMH, and THC values.Table 3-1: Analog Output ConnectionsPin Function3 Channel 2, + 4-20 mA, floating4 Channel 2, – 4-20 mA, floating5 Channel 1, + 4-20 mA, floating6 Channel 1, – 4-20 mA, floating8 Channel 2, 0-1 VDC23 Channel 2, 0-1 VDC, negative ground24 Channel 1, 0-1 VDC7 Channel 1, negative ground3.3.3.5 ALARM RELAYSThe nine alarm-circuit connector pins connect to the internal alarmrelay contacts. Each set of three pins provides one set of Form C relaycontacts. Each relay has both normally open and normally closed contactconnections. The contact connections are shown in Table 3-4. They arecapable of switching up to 3 amperes at 250 VAC into a resistive load.The connectors are:Threshold Alarm 1:Can be configured as high (actuates when concentration is abovethreshold), or low (actuates when concentration is below threshold).Can be configured as failsafe or non-failsafeConfigured as non-latchingCan be configured out (defeated).Can be set to trigger by levels of CH4, NMH, or THC.30 Teledyne Analytical Instruments
InstallationThreshold Alarm 2:Can be configured as high (actuates when concentration is abovethreshold), or low (actuates when concentration is below threshold).Configured as failsafe or non-failsafeConfigured as non-latchingCan be configured out (defeated).Can be set to trigger by levels of CH4, NMH, or THC.System Alarm:Actuates when power is removed from analyzer.It is triggered if 4040 fails to ignite after five times.Note: (Reset by pressing the STANDBY button to remove power.Then press STANDBY again and any other button exceptSYSTEM to resume. Further detail can be found in Chapter 4,Section 4.5.15.Table 3-4: Alarm Relay Contact PinsPin Contact45 Threshold Alarm 1, normally closed contact28 Threshold Alarm 1, moving contact46 Threshold Alarm 1, normally open contact42 Threshold Alarm 2, normally closed contact44 Threshold Alarm 2, moving contact43 Threshold Alarm 2, normally open contact36 System Alarm, normally closed contact20 System Alarm, moving contact37 System Alarm, normally open contactTeledyne Analytical Instruments 31
Page 9 and 10: Table of ContentsSafety Messages ..
Page 11 and 12: 4.5.2 Expanded menus 494.6 Setting
Page 13 and 14: List of TablesTable 3-1: Analog Out
Page 15 and 16: IntroductionIntroductionTeledyne An
Page 17 and 18: Operational Theory Series 4040Opera
Page 19 and 20: Operational Theory Series 4040SENSO
Page 21 and 22: Operational Theory Series 4040The a
Page 23 and 24: Operational Theory Series 4040If au
Page 25 and 26: InstallationInstallationInstallatio
Page 27 and 28: Installation3.3.2 Gas ConnectionsTh
Page 29: Installation3.3.3.1 PRIMARY INPUT P
Page 33 and 34: Installation3.3.3.7 RANGE ID RELAYS
Page 35 and 36: Installation3.3.4 RS-232 PortThe di
Page 37 and 38: Installation3.3.5.2 EFFLUENTAll the
Page 39 and 40: InstallationFigure 3-3: Front Panel
Page 41 and 42: InstallationTeledyne Analytical Ins
Page 43 and 44: OperationOperation4.1 Analyzer Oper
Page 45 and 46: OperationScreen Modes:Screen Readou
Page 47 and 48: Operation5. When the selected optio
Page 49 and 50: Operation12. TIMING: Low level appl
Page 51 and 52: OperationDAC A - GOODDAC B - GOOD--
Page 53 and 54: Operation-----------------------STA
Page 55 and 56: OperationNote however, that the ins
Page 57 and 58: OperationReenter a new Password'A'
Page 59 and 60: Operation Start the diagnostic test
Page 61 and 62: Operationconcentration. If an activ
Page 63 and 64: OperationRANGE LIMITS: Ranges may b
Page 65 and 66: OperationTo exit STANDBY, scroll ag
Page 67 and 68: AppendixAppendixA.1 Specifications
Page 69: AppendixSend orders to:TELEDYNE INS

4040 - Methane / Nonmethane analyzer - Teledyne Analytical ...

Create successful ePaper yourself

Delete template?

Save as template?