Effect of Automatic Sprinkler Protection on Smoke Control Systems

More documents

Recommendations

Info

stages <strong>of</strong> a ftre, some pressure difference is created by theexpansion <strong>of</strong> the air on the fire floor as it is heated. Forsustained, shielded fires, such as those used in theseexperiments, .however, the net temperature differencebetween the fire floor and the other 'zones was the primarysource <strong>of</strong> fire-induced pressure. The effect <strong>of</strong> the sprinklerspray was to greatly reduce the temperature on the firefloor, with a corresponding reduction in the buoyancypressure differences between the fire floor Md adjacentspaces.Pressures were measured at four elevations in both theone-story test room and the seventh floor <strong>of</strong> the Tower,ranging from close to the floor to close to the ceiling. Allpressure. measurements were referenced to the adjacentnonfire space, such as the stairshaft in the Tower tests orthe Bum Hall for the tests in the one-story room. Thereference pressure is shown as a vertical line at AP = 0 inFigures 8 and 10 and as a horizontal line in Figure 9; Whenthe fire ·compartment was not purposely depressurized bybeing mechanically exhausted, the initial pressure in the firecompartment was equal to the pressure in the adjacentnonfire spaces, so that the t.P was zero. As the fire beganto grow, hot gases accumulated near the ceiling, creating atemperature difference between the floor and ceiling. Thehot, buoyant ceiling layer generated a positive AP near theceiling, while at the same time, the pressure near the floorbecame increasingly negative relative to the adjacent spaceas the fire drew air toward itself. Curve A in Figure 8shows a typical pressure pr<strong>of</strong>ile for a nonsprinklered fireunder this condition, with a positive and a negative pressurecomponent above and below the neutral plane, respectively.Curve B in the same figure shows the pressure pr<strong>of</strong>ile forthe (typical) case <strong>of</strong> a sprinklered fire: both the positive andnegative values <strong>of</strong> AP were at least SO% less than thepressures measured in a nonsprinklered fire due to cooling<strong>of</strong> the gases on the fire floor.The effects <strong>of</strong> sprinklers on the pressure conditions inthe one-story test room, with no mechanical exhaust inoperation, are shown in Figure 9. It is clear that as spraydensity increased, the maximum positive AP and negativeAP diminished significantly. At a spray density <strong>of</strong> about0.11 gpm/ft2 ( 4.S Llminm2), the peak pressure differenceswere reduced by at least SO% from the nonsprinklered case.fligher spray densities resulted in even greater reductions in'buoyancy pressure. Note that it has been standard practicein smoke control system design to allow a SO% reduction inthe design pressure difference for a sprinklered building(Klote and Fothergill 1983; NFPA 1988). This practiceappears to be appropriate for the conservative case <strong>of</strong>assumed minimal sprinkler density. For reasons describedearlier, in most real ·fire scenarios, the initial sprinklerdischarge will exceed the minimum, and the averagetemperature on the fire floor will be less than the activationtemperature <strong>of</strong> the sprinklers: It should be expected, therefore,that buoyancy pressures will be much less than SO%<strong>of</strong> the unsprinklered values.ASH RAE Transactions: ResearchComparison <strong>of</strong> Measured and Predicted PressuresAn equation is provided in Klote and Milke (1992) toestimate the magnitude <strong>of</strong> the buoyancy pressure generatedby a fire:whereAP =K, =T. ===~t.P = K, • (I/T 0-liT!) • H (1)pressure differential across a barrier,· in. H 2 0(Pa);coefficient,7.64 (3460);ambient or reference air temperature, •R {K);absolute temperature <strong>of</strong> the fire, 0 R (K); andheight above ( +) or below (-) the neutral plane,ft (m).AP is the pressure difference across a boundary, withtemperature T 0on the nonfire side and temperature 1j onthe fire side. H is the distance above or below the neutralplane, and K, is a coefficient that incorporates gas densityand unit conversions. Equation I calculates the maximumpressure difference (t.P) at distance H above or below theneutral plane, based on the difference in temperatures onthe fire floor (Tj! and on the nonfire side <strong>of</strong> a barrier (T 0).To perform the calculation, it is necessary to estimate theelevation <strong>of</strong> the neutral plane (hence H) and to assume a"fire temperature" representative <strong>of</strong> the average conditionin the fire compartment. Uncertainties about the height <strong>of</strong>the neutral plane and in the calculation <strong>of</strong> the fire temperature,both vertically and horizontally in the fire compartment,however, lead to difficulties in predicting fire-inducedbuoyancy pressure· differences. Klote (1990) found thatpredicted pressure differences across a barrier using theaverage measured temperature at the barrier were in goodagreement with measured pressure differences.For the r-ase <strong>of</strong> no mechanical exhaust <strong>of</strong> the fire floor,this positive AP ceiling shown in Figure 8 was measureddirectly by the instrumentation. When the fire compartmentis mechanically exhausted, however, and adjacent spacesare purposely pressurized in order to create a zoned smokecontrol condition, the elevation <strong>of</strong> the neutral plane on thefire floor becomes uncertain. In that case, the pressurepr<strong>of</strong>ile for the fire floor is drawn into the negative region,relative to the stairshaft, which is equivalent to raising theneutral plane above the ceiling <strong>of</strong> the fire floor, as shownin Figure 10. For the purposes <strong>of</strong> analyzing the experimentalmeasurements <strong>of</strong> the effects <strong>of</strong> sprinklers on buoyancypressures under conditions <strong>of</strong> mechanical exhaust <strong>of</strong> the firefloor, it was useful to work with the net pressure differenceacross the wall <strong>of</strong> the stairshaft between the floor and theceiling <strong>of</strong> the fire floor, or I!..P•, as illustrated in Figure 10,instead <strong>of</strong> AP calculated from Equation 1. From Figure 10it can be seen that AP• will equal AP when the value <strong>of</strong> Hin Equation I equals the floor-to-ceiling height <strong>of</strong> the firefloor. Because the instrumentation measured the AP at thefloor and ceiling levels relative to the adjacent nonfire503
I______'I·····------,+ ..,..y_;~---41'* -0.07 in. H20 (typ)MJceil-0.03 'A~_J_b==~~~~==~~~==~==~...0.~4 ...0.02 0 0.02 0.044Pf1oor - ..0.04Presswe, in. H2000.04<strong>Sprinkler</strong> spray density, Lpm/m 22 3 4 5 6 7I0,03 - Press~m:~ ner ceiling -0.02o .. 0.01"'...!:l: 0.00..:
Page 4 and 5: smoke from the building. Studies su
Page 6 and 7: hI'J]48'i'12.8'Air Serv. Eev. Eev.
Page 8 and 9: 1An uncertainty analysis, applied t
Page 10 and 11: fire source and contributes to incr
Page 14 and 15: horizontally throughout the fire co
Page 16 and 17: tions of 10,000 pp
Page 18 and 19: Ipressurized zone before opening do
Page 21 and 22: LiP design = 0.05 in. H20 (12.5 Pa)

Effect of Automatic Sprinkler Protection on Smoke Control Systems

Create successful ePaper yourself

Delete template?

Save as template?