assembly instructions - Media.hobbypeople.net - Global Hobby ...

❑ Test-fit and glue the tail skid into place, using a generous amount of glue.+ Make sure that the tail skid faces toward the back of the fuselage andthat it's lined up straight with the bottom of the rudder.Step 2: installing the landing gear wires❑ Cut away the covering material from over the landing gear mounting slotin the bottom of the fuselage.❑ Insert the 90º bend in each of the landing gear wires into the predrilledholes in the mounting slot.❑ Push the landing gear wires firmly down into the slot.❑ Position the two nylon straps over the landing gear wires, 5/8" (16mm)in from the fuselage sides.❑ Mark the locations of the mounting screws onto the fuselage.IMPORTANT Make sure that the nylon straps are centered over thelanding gear wires when you mark the positions of the mounting screwholes.❑ Drill four 1/16" (1.6mm) diameter pilot holes through the fuselage at themarks you drew.❑ Install the two nylon landing gear straps, using four M2 x 10mm woodscrews, to hold the landing gear wires in place.Step 3: installing the wheels❑ Push one nylon spacer completely onto each axle.Page 17