Wadkin C5 C6 C7 C8 C9 Bandsaw Manual and Parts List

TRACKING OF SAWBLADE ON 1o/!OOi)LS.Every aawblade has dif'f'erent running characteriai tcs on a bandsaw machine~ due toTRACKINGOFSAWBLADE ON wm:ELS.Everysawblade .hasslightlydif'f'erent running characterisi tics on a bandsaw machinedue to the condition of' the steel ribbon f'rom which the blade is made, the bladejoints and tension in the blade ribbon. This is compensated by using a crownedorsUghtly curved tyre on the wheeland providing the top wheel with slight tiltingadjuStment.To check the tracking of'sawblade, f'ollow the undementioned procedure:1. Isolate machine electrioally.2. Open top ~and bottom doors.). Rotate the top wheel slowly by hand in a clockwise direction and check theblade is running oentral on the wheels.4. If' not rllnning central, loosenwingnut "B",FIG.B, then turn handwheel "C"untillsaw .i:s tracking correctly, i.e. in the centre of' both wheels.5. 'When tracking is. correct, tighten wingnut "B". This adjustment is mostimPortant, ·that thesawbJ.ade, when tracking co=ectly,passes in a straightlinebstween top and bottom wheels and does not shake, - when the latteroccurs, the back of' thesawblade keeps hitting the back guide roller and------DANGER: DO NOT TRACK BLADE WITH MOTOR RUNNING.TENSIONING SAWBLADE. (Without tension scale).Thesawblade shouJ.dal~ be tensioned correctly to achieve ma.ximum blade life.~e:t'-tension 04:tJiLadecoul:d result in saw damage.To tension bJ.ade co~ctly, proceed as follows:1 .• Isolate ma.chinselectrically.2. Turnhandwheel "All FIG.B, until blade can be pulled 61IDD (t") from itstrue line at central point between wheels. Blade is then tensioned co~ctly.www.wadkin.cominfo@wadkin.com