Wadkin C5 C6 C7 C8 C9 Bandsaw Manual and Parts List

14SETTINGTOPSA1IKlUIDEUNIT.A sawguide unit "A", FIG. 12 , is fitted above the table and is fully adjustablefor adequate aawbladesupport. The unit is fitted with TELLO!!" cappeL b 'b:leclcsaftda long rirebe6ziag.~I A similar guide unit for below the table can be supplied as an optionalextra.To set top guide assembly, proceed as follows:1. Isolate machine electrically.2. Loosen caphead screws "B", FIG11, arid remove sawguard "C".3· ,Loosen grubscrew "A" and M10 nut "B", FIG.12. then position guide body "C"central and parallel to blade'SEE FIG. 13, then tighten up grubs crew "A" andM10nut "B", FIG.12.NOTE: Once the guide ,has been initially set up, adjustment as described in- paragraph 4 should only be necessary.4. Slacken thumb screw "Y" FIG.12, and set rear guide roller 1/64" clear ofback of blade ,lockup thumbscrew "Y".S. 'Slacken thumb screws "X" FIG.12, and move side guide foreward as positionedin FIG.14, then pivot side guide rollers on anti lock eccentrics just clear.of blade FIG. 13, and lock thumb screws"X"NOTE: It is important that side guide rolle,i-a do not nip blade are set justclear.6. Refit sawguard "C", FIG.11 and secure with caphead "B".TO VERTICALLY ADJUST TOP GUIDE UNIT, PROCEED AS FOLLOWS:1. Isolate machine electically.2. Hold guide assembly "A", FIG. is, then 100Jen handwheel "B".J). l'ositiongu1de assembly "A" as required then relock handwheel "B".SETTING BOTTOM SAWGUIDEUNIT IF FITTED AS OPTIONAL EXTRA.The bottom sawguide unit is fitted below the machine table and is set ~ingsimilar procedure to top sawguide unit.www.wadkin.cominfo@wadkin.com