Wega 401 M2.40 FKW - EWM Hightec Welding GmbH

More documents

Recommendations

Info

Design and functionSelect welding task5.9.4 Spool brake setting1Item Symbol Description 0Figure 5-91 Allen screwSecuring the wire spool retainer and adjustment of the spool brake• Tighten the Allen screw (8 mm) in the clockwise direction to increase the braking effect.NOTETighten the spool brake until the wire spool no longer turns when the wire feed motor stops butwithout it jamming during operation!5.10 Select welding task5.10.1 Welding machine control M1.025.10.1.1 Setting the operating point (welding output)This control works according to the twin-knob operation principle. To set the operating point, only the wirespeed and the welding voltage need to be set according to the material and the electrode diameter.OperatingelementActionResultWire speed settingWelding voltage setting5.10.1.2 Welding parameter ignition time "tZn" diagramNOTEIn the ignition time, the wire feed continues to run at creep speed after the arc is ignited;the ignition behaviour is improved with the optimum setting.The process described below is always used if there is a pause between welding processes ofnot less than 1.5 seconds.40099-005224-EW50108.11.2011
Design and functionSelect welding taskFigure 5-10Legend with an explanation of symbols can be found in the MIG/MAG function sequences /operating modes chapter.099-005224-EW50108.11.201141
Page 6: Safety instructionsNotes on the use
Page 9: Safety instructionsGeneralWARNINGEx
Page 12 and 13: Safety instructionsTransport and in
Page 14 and 15: Safety instructionsAmbient conditio
Page 16 and 17: Machine description - quick overvie
Page 26 and 27: Design and functionGeneral5 Design
Page 28 and 29: Design and functionMains connection
Page 30 and 31: Design and functionWelding torch co
Page 32 and 33: Design and functionWelding torch an
Page 34 and 35: Design and functionShielding gas su
Page 36 and 37: Design and functionShielding gas su
Page 38 and 39: Design and functionInserting the wi
Page 42 and 43: Design and functionSelect welding t
Page 50 and 51: Design and functionMIG/MAG function
Page 57 and 58: Rectifying faultsCustomer checklist
Page 59 and 60: Rectifying faultsResetting the cont
Page 61 and 62: Technical dataWega 4018 Technical d
Page 63 and 64: Replaceable partsWire feed rollers1
Page 65 and 66: Appendix ARecommended settings11 Ap

Wega 401 M2.40 FKW - EWM Hightec Welding GmbH

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?