Wega 401 M2.40 FKW - EWM Hightec Welding GmbH

More documents

Recommendations

Info

Design and functionSelect welding task5.10.3.2 Setting the operating point (welding output)NOTEThe operating point setting in JOB "0" (manual) is carried out as described in the chapterof the same name for control M2.4x. The following settings are therefore only intendedfor work in JOBs 1-24.OperatingelementActionn xResultSelect the parameter via which the welding output is to be set:using the panel thicknessusing the wire speedusing the welding current+ +Hold down the "TEST" button and at the same time set the operatingpoint on the step switch.The display shows the required parameters and the open circuitvoltage.If the "Volt" and "Wire feed correction" diodes are flashing, this indicatesan error (e.g. short circuit between torch and workpiece, inductivityerror, etc). To correct the error, press "TEST" again.If the operating mode has already been selected, all the necessary settings will have beenactivated and welding can be started.5.10.3.3 Setting the wire correctionThe wire speed (arc length) can be modified using the wire correction if required.OperatingelementAction ResultSet the wire correction value46099-005224-EW50108.11.2011
Design and functionSelect welding task5.10.3.4 Setting the operating mode and runtime parametersNOTEThe parameter values set are preset in the JOB and can be modified if necessary.OperatingelementActionn xn xResultSelect operating mode:Non-latchedLatchedSpotsIntervalSelect welding parameter:Set gas post-flow time "GnS"(0.0 s to 10.0 s)Set wire burn-back time "drb" (-50% to 50%)Spot/interval time "t1" (0.1 s to 5.0 s)Interval/pause "t2" (0.1 s to 2.0 s)The selected parameter is shown on the displaySet the parameter chosen099-005224-EW50108.11.201147
Page 6: Safety instructionsNotes on the use
Page 9: Safety instructionsGeneralWARNINGEx
Page 12 and 13: Safety instructionsTransport and in
Page 14 and 15: Safety instructionsAmbient conditio
Page 16 and 17: Machine description - quick overvie
Page 26 and 27: Design and functionGeneral5 Design
Page 28 and 29: Design and functionMains connection
Page 30 and 31: Design and functionWelding torch co
Page 32 and 33: Design and functionWelding torch an
Page 34 and 35: Design and functionShielding gas su
Page 36 and 37: Design and functionShielding gas su
Page 38 and 39: Design and functionInserting the wi
Page 40 and 41: Design and functionSelect welding t
Page 50 and 51: Design and functionMIG/MAG function
Page 57 and 58: Rectifying faultsCustomer checklist
Page 59 and 60: Rectifying faultsResetting the cont
Page 61 and 62: Technical dataWega 4018 Technical d
Page 63 and 64: Replaceable partsWire feed rollers1
Page 65 and 66: Appendix ARecommended settings11 Ap

Wega 401 M2.40 FKW - EWM Hightec Welding GmbH

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?