CSA-32e.pdf 1289KB May 02 2006 12:07:50 PM - DCC Supplies

More documents

Recommendations

Info

Details for wiringthe CAN-bus canbe found in theZimo and STPmanuals.As already mentioned, the CAN-bus is connected to sockets K6 and/or K7.It doesn’t matter which socket is used since they are internally wired inparallel.To increase the reliability of data transmission and to take the load of theground circuit in the CAN-bus cable, install a separate ground wirebetween the MX1 command station (connection marked as “Masse”) andthe K9 spade terminal.Connecting the 2 pins of the jumper J1 causes the CSA-32 to reset tofactory default values. This action is not needed under normalcircumstances. A reset can also be carried out by disconnecting the powerfor at least 5 seconds.13
3.3 Digital Inputs and OutputsOccupancy detectors, PLV-32 and PTP-64 modules are connected tosockets K3 and K4. These sockets are chosen as SUB-D because wires andconnectors are reasonable in price.SUB-D connectorsand sockets areused for the serialconnection to thePC.The CSA-32 module can be used in 5 different operating modes, which canbe activated via CAN-bus, e.g. using a PC with STP software. The 5 modesare:1. 32 digital input2. 32 digital output (this mode is not supported by STP)3. Controls up to six PLV-32 amplifier modules, for a total of 192bulbs/LED’s4. Controls up to six PTP-64 amplifier modules, for a total of 192 pushbuttons5. 32 digital input but invertet voltage levels (+5V = 0. 0V = 1)The 32 in and outputs are assigned to two sockets as follows:In/output 1 - 24: socket K3, pin #1 - 24Ground: socket K3, pin #25In/output 25 - 32: socket K4, pin #1 - 8Ground: socket K4, pin #9The pin numbers are printed on the sockets.Mode 1 and 5 may be used for occupancy detectors which indicateoccupancy according to the following logic:Mode 1: +5V = occupied, 0V = unoccupiedMode 5: +5V = unoccupied, 0V = occupiedPlease note that STP at the moment supports only 24 occupancy detectorsper CSA-32 module, connected to pins #1-24 of socket K3. Pin #25 isground and connected to each detector as well.14
Page 1 and 2: Instruction manual toCAN-Interface
Page 3 and 4: Content1. General Notes............
Page 5 and 6: 1.2 DescriptionThe CSA-32 module is
Page 7 and 8: This page is left blank on purpose4
Page 9 and 10: Qty Code Description Value Conrad #
Page 11 and 12: 2.3 Module AssemblyLocate all the c
Page 13 and 14: Sockets (K1, K3, K4, K6, K7, K8, K9
Page 15: Address DIP Switch 2) Address DIP S
Page 19 and 20: 3.4 Power-up and testing with CANVi
Page 21 and 22: The “New Transit message” windo
Page 23 and 24: 3.5 Inclusion in STPSTP can use CSA
Page 25 and 26: Q: Even though the module starts up
Page 27: • The module is to be operated on

CSA-32e.pdf 1289KB May 02 2006 12:07:50 PM - DCC Supplies

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?