12.07.2015 Views

Waterford Systems - Rick English - Swimming Pool Consultant

Waterford Systems - Rick English - Swimming Pool Consultant

Waterford Systems - Rick English - Swimming Pool Consultant

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

READ AND FOLLOW SAFETY INSTRUCTIONS!This is the safety-alert symbol. When you seethis symbol on your valve or in this manual, lookfor one of the following signal words and be alert tothe potential for personal injury.warns about hazards that will cause seriouspersonal injury, death or major property damageif ignored.warns about hazards that can cause seriouspersonal injury, death or major property damageif ignored.warns about hazards that will or cancause minor personal injury or property damage if ignored.The label NOTICE indicates special instructionswhich are important but not related to hazards.Carefully read and follow all safety instructions inthis manual and on system.Keep safety labels in good condition.Replace missing or damaged safety labels.Incorrectly installed or tested equipmentmay fail, causing severe injury orproperty damage. Read and follow instructionsin owner's manual when installing and operatingequipment. Have a trained pool professionalperform all pressure tests.1. Do not connect system to a high pressure or citywater system.2. Use equipment only in a pool or spa installation.3. Trapped air in system can cause explosion. BESURE all air is out of system before operating ortesting equipment.Before pressure testing, make the following safetychecks:• Check all clamps, bolts, lids, and system accessoriesbefore testing.• BE SURE all air is out of system before testing.• Tighten Sta-Rite trap lids to 30 ft. lbs. (4.1 kg-cm)torque for testing.• Water pressure for test must be less than 25 PSI (172kPa).• Water temperature for test must be less than 95˚ F.(35˚ C).• Limit test to 24 hours. After test, visually check systemto be sure it is ready for operation. Remove traplid and retighten hand tight only.NOTICE: These parameters apply to Sta-Rite equipmentonly. For non-Sta-Rite equipment, consult manufacturer.WHEN USING SYSTEM:Hazardous Pressure!Can cause tankexplosion.Do not test withcompressed airor operate aboverated pressure.WHEN USING SYSTEM:Hazardous suction.Can trap or tearhair or body parts,causing severe injuryor death.Do not block pumpsuction or pool maindrain.BEFORE WORKINGON PUMP OR MOTOR:Hazardous voltage.Can shock, burn,or cause death.Unplug pump motor.3

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!