EFIS-D60 Installation Guide - Dynon Avionics

More documents

Recommendations

Info

AppendixAppendix D: Replacing the EFIS-D60 Internal Backup Battery1. Remove the two screws (either #1 Phillips or 7/64” hex, depending on when your unitwas manufactured) from the small, rectangular battery door on the side of the EFIS-D60.Remove the battery door. Do not remove any other screws from the case of the unit.2. If you previously had a battery, disconnect it from the EFIS-D60 by unplugging thebattery connector and gently pulling out old battery. It is safe to gently pull on the batterywire to remove the battery.3. Insert the new battery with the bumpy side up.4. Connect the battery connector to the battery. The connector is keyed; make sure it ispositioned correctly.5. Position the connector so it is centered on the end of the pack. Verify that the batterypack will not interfere with insertion of either of the door screws.6. Reinsert screws and tighten to 12 in-lbs.Appendix E: Upgrading EFIS-D60 to EFIS-D100The EFIS-D60 is Dynon’s simple, more affordable version of Dynon’s full-featured EFIS-D100.Your EFIS-D60 can be upgraded to the feature set of the EFIS-D100, which provides thefollowing features and more:• HSI Capability• Optional autopilot interface• GPS and NAV radio interconnectivity• Interoperability with other Dynon instruments• Checklists• Bugs• Timers• On-screen information such as clock, VSI, OAT, G-meterThe upgrade process can only be done at the factory. Contact Dynon Customer Support(support@dynonavionics.com or 425-402-0433) for upgrade pricing, turnaround time, and otherdetails.5-18 EFIS-D60 Installation Guide
AppendixAppendix F: WeightsAdding any new instrument to an aircraft requires the installer to be aware of its weight and howthat affects the overall weight and balance of the plane. The following are the weights of theEFIS-D60 and associated Dynon-supplied sensors.Installed EFIS-D60 .......................................................................................2 lb 13.5 oz (1.287 kg)EFIS-D60 + Internal Backup Battery ................................................................3 lb 4 oz (1.465 kg)EFIS 25-pin wiring harness ...................................................................................11.2 oz (0.32 kg)EDC-D10A ............................................................................................................3.6 oz (0.102 kg)EFIS OAT ................................................................................................................3.2 oz (0.08 kg)Heated AOA/Pitot Probe & Heater Controller ......................................................11.2 oz (0.32 kg)Unheated AOA/Pitot Probe......................................................................................5.6 oz (0.16 kg)Appendix G: EFIS-D60 SpecificationsMechanicalOperatingTemperature6.95” wide x 4.90” tall x 4.51” deep (177 x 125 x 115 mm)-22° to 122° F (-30° to 50° C)PowerVoltage:Power:10 - 30 Vdc12 watts typical; 17 watts maximumConnections Wiring: DB25 male connectorScreenType:Backlight:Size:Resolution:AMLCD, TFT (Thin Film Transistor)800 nits7.0” diagonal (178 mm)854 x 480 color pixelsInputs/Outputs1 - AOA Audio Alarm1 - RS-232 bidirectional PC communication and GPS aidinginput1 - RS-232 serial encoder outputEFIS-D60 Installation Guide 5-19
Page 1: EFIS-D60Installation GuideThis prod
Page 5: Table of ContentsContact Informatio
Page 8 and 9: IntroductionAbout this GuideIn the
Page 10 and 11: Wiring Overview25-Pin Female EFIS H
Page 12 and 13: Wiring OverviewWIRING SYSTEM OVERVI
Page 14 and 15: Instrument Installation• All moun
Page 16 and 17: Instrument InstallationPC CONNECTIO
Page 18 and 19: Instrument InstallationSERIAL ALTIT
Page 20 and 21: Instrument InstallationPanel Locati
Page 23 and 24: 4. EFIS CALIBRATION AND CONFIGURATI
Page 25 and 26: EFIS Calibration and ConfigurationE
Page 27 and 28: 5. APPENDIXThe appendices contain a
Page 29 and 30: Alert Message Description End condi
Page 31 and 32: AppendixProblemAfter performing a m
Page 33 and 34: AppendixAppendix B: Dynon AOA/Pitot
Page 35 and 36: Appendixinstructions on the followi
Page 37 and 38: Appendixcontroller. Remember that e
Page 39 and 40: AppendixBoom mountPLUMBINGNOTE: Bec
Page 41 and 42: AppendixAppendix C: Encoder Serial-
Page 43: AppendixEFISDB25Pin#13Dynon EFIShar

EFIS-D60 Installation Guide - Dynon Avionics

Create successful ePaper yourself

Delete template?

Save as template?