Operating Instructions - VEGADIS 62 -

6 Set updigital indication is configured according to the measuring range andthe unit of the connected sensor. After interrupting the power supply orif the digital indication was set manually, then the heart symbolextinguishes.As long as a HART communication takes place from the control room,then the heart symbol flashes in the display.The heart symbol is not displayed during operation in basic mode.6.3 HART multidrop modeOperation of the VEGADIS 62 in Multidrop mode is possible. In thisspecially defined operating status for HART sensors, the current signalis fixed at 4 mA and the measurement information is only transmittedvia HART communication to the control room. To enable the indicationof the measured value of a transmitter, the address of the requestedtransmitter must be set in the menu item "Adresse".The VEGADIS 62 shows the measured values of the primary variabletransmitted via HART to the control system. The display reactspassive, this means that the transmission of the measured values mustbe requested by the control system.6.4 Parameter adjustmentWith the parameter adjustment, the instrument is adapted to theapplication conditions. The parameter adjustment is carried out via anadjustment menu.The main menu is divided into three areas with the following functions:Measurement: Contains for example unit, measuring range, liveadjustment, damping, HART addressIndication: Contains for example unit, unit locking, display format,filter, alarms min./max. storageConfiguration: Contains for example language, contrast, reset, userunit, min./max. failure message, firmware versionMeasurement/UnitMenu section measurementAdjustment of the unit of the measuring range of the connectedtransmitterl Electrical measured variable: V, mA, Ohml Pressure: bar, mbar, PSI, hPa, kPa, mmH2O, mH2O, inHG22 VEGADIS 6236469-EN-100514