owneRs manual: Handling & SafeTy inSTrucTionS - Sig Sauer

when it counts TO CLEAR A STOPPAGE (JAM)6.0. Procedures In Case of a StoppageA “Stoppage” is an interruption in the cycle of operation as depicted in Section 4.0. A stoppage can normally be repairedby the operator by performing one of the following immediate actions described.6.1. Failure to Fire (Cold Rifle) Trigger is pressed, hammer falls, rifle does not fire.1. Ensure the magazine is properly seated in the magazine well by applying upward pressure and then pulling down onthe magazine.2. Retract the charging handle all the way back and observe the ejection of the expended case or a live cartridge; and3. Visually inspect the chamber for any obstructions, if the chamber shows to be clear, release the charging handle tofeed a new cartridge. Do NOT ride the charging handle forward.4. Attempt to fire the rifle again.www.sigsauer.com 51