owneRs manual: Handling & SafeTy inSTrucTionS - Sig Sauer

when it counts 9.5. Rejoining Upper and Lower ReceiversTo aid in steps 1-3, manually cock the hammer by pushing it down until it is held in place then rotate the fire controlselector to SAFE.1. Position the upper and lower receivers to align the pivot pin (front pin) holes.2. Push the pivot pin from right to left until the head of the pivot pin is flush against the receiver. You will feel it capturedby the detent pin.3. Close the receivers together and push the takedown pin (rear pin) from right to left until the head of the takedown pinis flush against the receiver. You will feel it captured by the detent pin as you did the pivot pin.9.6. Quad Rail Reassembly1. Pre-assemble the rail clamp and quad key to the lower rail section leaving the two (2) clamp screws loose.FIG 48 QUAD KEY AND RAIL CLAMP PRE-ASSEMBLEDwww.sigsauer.com 75