05-6193A01-A - GE Digital Energy

More documents

Recommendations

Info

3.5 Task-Oriented Menu ChartTable 1 is a task-oriented listing of user and maintenance tasks. To usethe table, find the task you wish to perform, and then refer to the farright-hand column for the specific menu(s) to use. Additional coverageof menu tasks is provided in “Using the Menu System—CommonTasks” on Page 12 which immediately follows this table.Table 1. Menu Selection ChartTaskCategoryView OverallStatus & PerformanceInformationIf you wish to...View top-level unit information (OwnerName/Message, Unit Number, IP Address, SerialNo., Firmware version, Run time, Alarm presence,etc.)View Radio Performance data (Power Output,Signal-to-Noise Ratio, Received Signal Strength, DCInput voltage, operating temperature)View Serial No., Model 1 (hardware), Model 2(software) version, Firmware Version, Build DateView Bootloader version information, ActiveFirmware Image, Firmware Version levelView Alarm/Event information, I/O Statistics,Ethernet StatisticsRefer to thisMenu>>Submenu(s)Starting Information Screen(See Figure 7 on Page 13)Radio Performance(See Figure 8 on Page 13)Device Configuration>>Device Info(See Figure 9 on Page 14)Maintenance/Tools>>Version(See Figure 10 on Page 14)Statistics/Events>>Alarms/EventsEvent LogI/O StatisticsEthernet Statistics(See Figure 11 on Page 15 &following submenus)8 SD Series Serial-Telnet Supplement MDS 05-6193A01, Rev. A
Table 1. Menu Selection Chart (Continued)TaskCategoryView/Set Radio (RF)Operating ParametersView/Set DeviceConfigurationSecuritySettingsIf you wish to...Set RF Output Power, Modem Type, RX/TXFrequencyView/Set Soft-Carrier Dekey status, RX/TXTime-Out optionsData-Key and RTS-Key settings (ON/OFF)Push-to-Talk/Clear-to-Send Delay times (ms)Automatic Frequency Correction (AFC) settingSwitched Carrier ON/OFF settingConfigure Listen-Before-Transmit (LBT) collisionavoidanceView Received Signal Strength (RSSI) levelKey the radio transmitter, view power outputMonitor local radio emissions for possibleinterferenceView Serial No., Model 1 (hardware), Model 2(software) version, Firmware Version, Build DateSet Owner Name/Message, enable/disable SleepMode, set COM LED mode, Radio ModeConfigure radio to support multiple hosts on serialand Ethernet ports.Configure time delays to identify packets on serialportsConfigure Unit ID and/or DLINK diagnosticssettingsSet Password for radioSet Device Security (enable/disable local loginrequirement, enable/disable Telnet access)Set Wireless Security parameters (Encryption on/off,phrase, DLINK Security on/off)Refer to thisMenu>>Submenu(s)Radio Configuration>>Basic Settings(See Figure 16 on Page 18)Radio Configuration>>Advanced Settings(See Figure 17 on Page 20)Radio Configuration>>Advanced Settings(See Figure 17 on Page 20)Radio Configuration>>Advanced Settings(See Figure 17 on Page 20)Radio Configuration>>Advanced Settings(See Figure 17 on Page 20)Radio Configuration>>Advanced Settings(See Figure 17 on Page 20)Radio Configuration>>LBT Settings(See Figure 18 on Page 23)Radio Performance(See Figure 19 on Page 25)Radio Test>>RF Keying Test(See Figure 49 on Page 65)Radio Test>>Spectrum(See Figure 50 on Page 66)Device Configuration>>Device Info(See Figure 21 on Page 26)Device Configuration>>Device Settings(See Figure 23 on Page 28)Device Configuration>>Multihost Settings(See Figure 24 on Page 31)Device Configuration>>Packet Settings(See Figure 25 on Page 31)Device Configuration>>Diagnostic Settings(See Figure 27 on Page 34)Security Configuration>>Password(See Figure 29 on Page 36)Device Security Menu(See Figure 31 on Page 38)Security Configuration>>Wireless Security(See Figure 30 on Page 37)MDS 05-6193A01, Rev. A SD Series Serial-Telnet Supplement 9
Page 1 and 2: MDS SD SeriesSerial/Telnet Manageme
Page 3 and 4: TABLE OF CONTENTS1.0 INTRODUCTION .
Page 5 and 6: Copyright and TrademarkThis manual
Page 7 and 8: 1.0 INTRODUCTIONThis document is a
Page 9 and 10: NOTE:TX and RX frequencies may not
Page 11 and 12: 3.0 USING THE MENU SYSTEMThis secti
Page 13: Invisible place holderMENU SYSTEMOv
Page 17 and 18: Table 1. Menu Selection Chart (Cont
Page 19 and 20: Figure 7. Starting Information Scre
Page 21 and 22: Invisible place holderFigure 11. St
Page 23 and 24: The Ethernet Statistics Submenu (Fi
Page 25 and 26: 1) For MDS x710-compatible operatio
Page 27 and 28: TX Time-OutTX Time-Out protects aga
Page 29 and 30: 1. Select Switched Carrier from the
Page 31 and 32: A related setting to Timeout is Pac
Page 33 and 34: To view detailed version informatio
Page 35 and 36: 1. To select the LED Mode, access t
Page 37 and 38: Invisible place holderFigure 24. Mu
Page 39 and 40: Invisible place holderFigure 26. Me
Page 41 and 42: DLINK StatusThis item is used to en
Page 43 and 44: Setting the AES Wireless Security P
Page 45 and 46: Telnet AccessTelnet access is a pow
Page 47 and 48: 2. Enter an IPv4-compliant IP addre
Page 49 and 50: Basic Bridge FilterSelectionThe pur
Page 51 and 52: IP Payload is intended to be used i
Page 53 and 54: Setting the ModeThe operating mode
Page 55 and 56: The Terminal Server supports the fo
Page 57 and 58: TCP Server IP PortThis selection sp
Page 59 and 60: 1. Select Data ID on the menu. A fl
Page 61 and 62: DHCPDynamic Host Configuration Prot
Page 63 and 64: 2. Press the spacebar until the des
Page 65 and 66:
1. Select Data Format from the menu
Page 67 and 68:
To save the radio’s current confi
Page 69 and 70:
Invisible place holderFigure 47. Re
Page 71 and 72:
4. To dekey the radio, select Key R
Page 73 and 74:
Invisible place holderReprogramming
Page 75 and 76:
Invisible place holderRemote Reprog
Page 77 and 78:
Viewing Enabled FeaturesThe radio
Page 79 and 80:
Alarm Signal Mask(Hex)This selectio
Page 81 and 82:
Checking for AlarmsTo check for ala
Page 83 and 84:
Invisible place holderFigure 62. I/
Page 85 and 86:
1. Program one radio in the network
Page 87 and 88:
NOTE: It is possible for Remote rad
Page 89 and 90:
Invisible place holderFigure 65. Ma
Page 91 and 92:
From Menu Mode to...From Diagnostic
Page 93 and 94:
LOCAL PC WITH FIRMWARE FILEInvisibl
Page 95 and 96:
6. Access the Local Reprogram scree
Page 97 and 98:
APPENDIX-ACLI SCRIPTING INTERFACENO
Page 99 and 100:
Detailed Command DescriptionsALARMS
Page 101 and 102:
8N2—eight char bits, no parity, t
Page 103 and 104:
OFF—Sleep Mode offON—Sleep Mode
Page 105 and 106:
CLEAR—Clear selected statisticsMO
Page 107 and 108:
LOGOUTMENUMULTIHOSTLogs the user ou
Page 109 and 110:
MPT1411—Analog9600B—x710B compa
Page 111 and 112:
1—Minimum delay255—Maximum dela
Page 113 and 114:
IN CASE OF DIFFICULTY...GE MDS prod
show all

05-6193A01-A - GE Digital Energy

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?