05-6193A01-A - GE Digital Energy

Dlink Security SettingSecurity restrictions may also be applied to network-wide diagnosticdata using this menu. To enable or disable diagnostic security, selectDlink Security from the menu and press the spacebar to display OFF or ONin the field to the right, as desired. The default setting is OFF. PressENTER to apply the change.If Dlink Security enabled, users performing network-wide diagnostics mustlog in before being able to change the configuration of the radio viaDlink.MenuThe Device Security Menu (Figure 31) is used to set the access methodfor the transceiver’s menu system, and also to determine if Telnet accessis permitted.Invisible place holderFigure 31. Device Security MenuLocal Security(Login) SettingThe Local Security parameter is used to specify whether or not a locallog-in is required when using the transceiver’s menu system. The defaultsetting is Local Login Required, and is appropriate for most circumstances.Setting this parameter to No Local Login Required might be useful in caseswhere only a small number people with administrative duties have physicalaccess to the radio, and need to access the menu frequently. In thismode, the menu operation behaves identically to the Administrator levellogin.To change the Local Security setting, proceed as follows:1. Select Local Security from the menu. A flashing cursor appears in thefield to the right of the item.2. Press the spacebar until the desired selection is displayed. Availableselections are: Local Login Required, and No Local Login Required. PressENTER to apply the change.38 SD Series Serial-Telnet Supplement MDS 05-6193A01, Rev. A