05-6193A01-A - GE Digital Energy

Table 1. Menu Selection Chart (Continued)TaskCategoryEthernet PortConfigurationSerial PortConfigurationIf you wish to...Configure the IP settings (Static IP Address, Static IPNetmask, Static Default Gateway, DHCPenable/disable, Virtual Radio Channels–VRCs)Configure Ethernet BridgingConfigure the Ethernet Port settings (Enable/disableport, set mode, Local IP Port, Destination IP Address,Destination IP Port, TCP Keepalive time)Configure COM1 settings (Startup mode, Data BaudRate, Data format, Virtual Radio Channels–VRCs)Configure COM2 settings (Mode, Baud Rate,Format, Buffer on/off, Device Type, Virtual RadioChannels–VRCs)Refer to thisMenu>>Submenu(s)Ethernet Configuration>>IP Configuration(See Figure 33 on Page 40)Ethernet Configuration>>Bridge Configuration(See Figure 34 on Page 42)Ethernet Configuration>>Ethernet Data Port(See Figure 36 on Page 45)Serial Configuration>>COM1 Port Settings(See Figure 42 on Page 56)Serial Configuration>>COM2 Port Settings(See Figure 43 on Page 58)10 SD Series Serial-Telnet Supplement MDS 05-6193A01, Rev. A