Triton Topaz T100si - Faucets, Showers, Bathroom, Kitchen, More.

Topaz T100siOPERATING FUNCTIONSClean showerheadAfter a preset number of Start/Stop buttonoperations (nominally 75), the start up routineacts as normal but instead of a blue ‘OK’ thedisplay backlight turns red and a flashing ‘CS’alternating with a flashing ‘showerhead symbol’and ‘CLEAN’ appear (fig.30).This is a reminder to clean the showerhead. Itdoes not indicate a defect to the shower.To remove the red ‘CS’ from the display, pressthe power and cold buttons simultaneously forthree seconds. Alternatively you can choosenot to remove the flashing indication and carryon by pressing the Start/Stop button andshowering as normal, but the ‘symbol’ and‘CLEAN’ will continue to flash at the side of the°C figure for a further five shower operationsafter which time it will stop (whether you cleanthe showerhead or not). The shower will thenreset automatically for a further preset numberof shower operations before flashing thereminder again.Fig.30Fig.31Low pressureWhen the display backlight turns red and‘LP’ and ’low pressure’ flash alternately, itmeans the water pressure has fallen below theminimum required for correct operation of theshower (fig.31). This causes the low pressureswitch to operate and this turns off power tothe heating elements preventing any maintainedtemperature rises. Water will no longer flow untilthe unit has been reset.Press the Start/Stop button once to reset theshower. The shower will shut down and thenbegin its start up routine.If there is still not enough pressure for correctoperation the ‘low pressure’ display will flashonce more and the shower will require resettingagain.If there is enough pressure the display willchange to show ‘ok’ in a blue backlight and theshower will run as normal.17