12.07.2015 Views

Download the manual - Drolet

Download the manual - Drolet

Download the manual - Drolet

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Columbia Installation and Operation ManualThe gasket must be centred on <strong>the</strong> edge of <strong>the</strong> glass. To do this easily, peel back asection of <strong>the</strong> paper covering <strong>the</strong> adhesive and place <strong>the</strong> gasket on a table with <strong>the</strong>adhesive side up. Stick <strong>the</strong> end of <strong>the</strong> gasket to <strong>the</strong> middle of one edge, <strong>the</strong>n press <strong>the</strong>edge of <strong>the</strong> glass down onto <strong>the</strong> gasket, taking care that it is perfectly centred on <strong>the</strong>gasket. Peel off more of <strong>the</strong> backing and rotate <strong>the</strong> glass and press <strong>the</strong> next section onto<strong>the</strong> gasket. Do not stretch <strong>the</strong> gasket as you place it. Continue until you get to <strong>the</strong> start andtrim <strong>the</strong> gasket to length. Now pinch <strong>the</strong> gasket to <strong>the</strong> glass in a U shape, all around <strong>the</strong>glass. Reinstall <strong>the</strong> glass, being careful to centre <strong>the</strong> glass carefully in <strong>the</strong> door. Do notover-tighten <strong>the</strong> screws. Note that <strong>the</strong> two main causes of broken door glass are unevenplacement in <strong>the</strong> door and over-tightening of retaining screws.Do not abuse <strong>the</strong> glass door by striking or slamming shut. Do not use <strong>the</strong> stove if <strong>the</strong> glassis broken. To change <strong>the</strong> glass, perform <strong>the</strong> same operation described above.5.1.5 Cleaning and Painting <strong>the</strong> StoveDo not attempt to clean or paint <strong>the</strong> stove when <strong>the</strong> unit is hot. Painted surfaces canbe wiped down with a damp cloth. Plated surfaces may be scratched by abrasive cleaners.To maintain <strong>the</strong> finish at its original brilliance, use only a damp soft cloth to clean platedsurfaces.If <strong>the</strong> paint becomes scratched or damaged, you can give your wood stove a brand newlook by repainting it with heat-resistant paint. Before painting, roughen <strong>the</strong> surface with finesand paper, wipe it down to remove dust, and apply two thin coats of paint. For bestresults, use <strong>the</strong> same paint that was originally used on <strong>the</strong> stove, which is available inspray cans. See your dealer for details.5.2 Chimney and Chimney Connector Maintenance5.2.1 Why Chimney Cleaning is NecessaryWood smoke can condense inside <strong>the</strong> chimney connector and chimney, forming acombustible deposit called creosote. If creosote is allowed to build up in <strong>the</strong> ventingsystem it can ignite when a hot fire is burned in <strong>the</strong> stove and a very hot fire can progressto <strong>the</strong> top of <strong>the</strong> chimney. Severe chimney fires can damage even <strong>the</strong> best chimneys.25

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!