Open PDF - Harworth Heating Ltd

More documents

Recommendations

Info

The burner fires down into the boiler and is secured at three points; twohorizontal m8 grub screws and one m8 bolt fitted vertically at the rear of theburner.Front of boilerThe two m8 horizontal grub screws lock the burner flame tube into the castaluminium mounting flange and the vertical bolt is used to pull the burner downso that it sits level and at perfect right angle to the boiler, this is veryimportant as the flame must fire straight down into the centre of thecombustion chamber, any deviation could place excessive heat on to the topside heat shields and subsequent damage could ensue.Electrical power is supplied to it via a large multi pin plug, which has a latchedfastener.To remove the burner undo the two fasteners on the mounting flange anddisconnect the multi pin plug.The burner will still be attached to the oil line so take care not to damage,twist or kink the oil line.24
Work the burner out from the boiler by simultaneously rotating and lifting it upand out from the top of the boiler.Once the burner is removed from the boiler it can be stripped down and cleaned asfollows.7.3 TO REMOVE AND CLEAN THE FLAME TUBE.RemoveNozzle7.5 TO REMOVE EXAMINE AND ADJUST THE ELECTRODE.7.6 TO REMOVE AND CLEAN THE PHOTOCELL.The Photocell plugs into the side of the burner and can be unplugged and wipedclean.25
Page 1 and 2: +12 OR 24 VOLT DC PRESSURE JET BOIL
Page 3 and 4: 4.9 Fire Prevention. ______________
Page 5 and 6: The boiler can be used to heat up h
Page 7 and 8: If the input voltage is turned off
Page 9 and 10: As per normal convention hot water
Page 11 and 12: This is most important as the built
Page 13 and 14: 4.7 SCHEMATIC ELECTRICAL EXTERNAL C
Page 15 and 16: This means that the lower part of t
Page 17 and 18: If the appliance is fitted with a c
Page 19 and 20: 5A.2.♦ The word “CLOCK” to in
Page 21 and 22: The burner will attempt to fire and
Page 23: 7 ROUTINE MAINTENANCE7.1 INTRODUCTI
Page 27 and 28: 7.9 REMOVING THE BAFFLE SYSTEMS AND
Page 29 and 30: Relay 4 is used as a maintaining lo
Page 31 and 32: 8-3 12 VOLT DC TO 24 VOLT DC CONVER

Open PDF - Harworth Heating Ltd

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?