SIMOVERT Master Drives Einspeise-Einheit Bauform E Common ...

Transport, unpacking, assembly 02.962.3 Aids to assemblyThe following are required for securing: 4 M8 bolts dimension drawing (figure 2.2 for size E)WARNINGFor safe operation of the unit, it is presumed it will be assembled and commissioned byqualified personnel, paying attention to the warning notes given in these operatinginstructions.Particular note must be taken both of the general and national erection and safetyregulations regarding work on power installations (e.g. VDE) and regulations regarding theproper use of tools and of personal protective equipment.Non-observance of warning notices can result in death, severe personal injury orconsiderable property damage.The unit must be protected against the ingress of foreign matter as otherwise properfunctioning and safety will not be guaranteed.Requirements for the installation siteLocal guidelines and standards must be observed in relation to assembly.Operating facilities must be dry and dust-free. Air fed in must not containany gases, vapours or dusts that are electrically conductive or detrimentalto functioning. Air containing dust must be filtered.DissipatedpowerWARNINGDimension cabinet ventilation according to thedissipated power! (Technical data in Chapter 14)The unit’s ambient climate in operating rooms must not exceed the valuesof code 3K3 as detailed in DIN IEC 721 Part 3-3 /04.90. A reduction ofpower as detailed in Chapters 14.1 and 14.2 is necessary in the event oftemperatures > 40 °C (104 °F) and altitudes >1000m. The terminalvoltage has to be reduced for altitudes > 2000m.Carry out assembly in accordance with the dimension drawing inChapter 2.4.6SE70Cooling air≤ 40 °C (50 °C)Figure 2.1 Installation in control cabinets2-2 ENGLISH Siemens AG 6SE7087-6AE85-0AA0Common Rectifier Operating instructions