indesign installation manual v4-1.indd - Ready Remote

More documents

Recommendations

Info

4. Signal output connector (CON 2 )➀➁➂➃➄➅➆➇➈➉1112N/AYellowN/AGreen/WhiteWhiteBlueWhite/BrownBrown/WhiteRed/YellowRed/BlueN/ABrownParking light output ( 10A relay)Trunk Release output ( 10A relay)Starter interrupt Signal output ( 300mA transistor)Siren output ( 3A power transistor)Rearm output for factory Alarm ( 300mA transistor)disarm output for factory Alarm ( 300mA transistor)Auxiliary 1 output ( 300mA transistor)Auxiliary 2 output ( 300mA transistor)Dome light output ( 300mA transistor)➁ Yellow: Parking light output ( 10A relay)Parking light output (max of 10A) Connect this wire to theparking light wire in the vehicle. The correct wire in the vehicle will show 12volts only when the parking lights are turned on. When the parking lights areoff the wire will show 0 volts. NOTE: In most cases connecting to one wire inthe vehicle will illuminate all parking lights. If not, there will be multiple wiresyou need to power, isolating each wire with a relay. This is especially true inEuropean vehicles. Note: See the following diagram if your vehicle requires aNEGATIVE trigger to illuminate the parking lights.typeYellowtypeYellow10 <strong>v4</strong>.2
➃ Green/White: Trunk Release output ( 10A relay)This output provides a positive signal when the “Trunk Release”is activated. Refer to the following diagrams for proper connection.typeGreen/WhitetypeGreen/White➄ White : Starter Interrupt Signal output ( 300 mA transistor)The 300mA output is used to disable starter via an external relay.Blue (IGN #1)from CON1*Starter Interrupt Relay(not included)InterruptStart from module<strong>v4</strong>.211
Page 2 and 3: Before installing the systemModel #
Page 4 and 5: Precautions■ Airwolf is designed
Page 6 and 7: 2. Overall wiring diagram6 v4.2
Page 8: 3. 6-pin main harness (CON1)➀➁
Page 13 and 14: 12Brown : Dome light output (300 mA
Page 15 and 16: Type B: NegativeThis system supplie
Page 17 and 18: Type F: One Wire SystemThis system
Page 19 and 20: 9. Trigger input connector (CON 7)
Page 21 and 22: 9-6. White : Voltage Sense (optiona
Page 23 and 24: 10. Programming the remote controlS
Page 25 and 26: Programming if connected in Voltage
Page 27 and 28: (Example) of how to configuring tru
Page 29 and 30: 12 - 8 IGN 1 ON waiting timeYou can
Page 31 and 32: 15. Relay diagramOrange(Ground)Note
Page 33 and 34: MEMOv4.233
Page 35: MEMOv4.235

indesign installation manual v4-1.indd - Ready Remote

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?