indesign installation manual v4-1.indd - Ready Remote

12 - 8 IGN 1 ON waiting timeYou can configure IGN 1 ON waiting time that determines the time between turning IGN ONand operating the starter motor when the brain attempts engine start.● Note - If the vehicle is diesel and the warm-up sense wire is connected, thestarter motor is operated when the warm-up sensor detects the glow plugs- regardless of this setting. Otherwise, the vehicle will crank when theprogrammed time has expired.12 - 9 Starter motor operation time● when connected in alternator/voltage sense mode there is no need to changethis time if the vehicle starts consistently. If the start overcranks, reduce the time.If the start does not crank long enough increase the time. Adjustable from 0.1to 1 second.● when it connected in TACH mode this setting controls the number of tach pulsesthe unit must see before releasing the starter. A lower setting will fine tune the unitto disengage the start earlier, while a higher value will cause the unit to crank thevehicle longer. Adjustable from 1 to 10 tach pulses.12 - 10 ExitThis menu is used to finish the configuration without transmitting the changed configurationto the brain. The changed values are saved in the permanent memory of the remote control,and you can transmit the values later.● Note - The values must be saved to the brain for them to be active. To save to thebrain press the “A” button.v4.229