indesign installation manual v4-1.indd - Ready Remote

Programming if connected in Voltage Sense modeIf the Alternator/Tachometer wire *IS NOT* connected to the tach wire asper PAGE 19, perform the steps below. Do NOT use the Green Tach wire.Connect the WHITE Voltage Sense wire to a source of 12 volts constantpower. This 12 volt source will allow Air Wolf to measure the output of thealternator.Step 1● Open the doorStep 2Step 3DIPSwitchManual/AutomaticLoop● Place the DIP switch at ON position.Alternatively you may open thehood if the hood pin switch isproperly installed.● If you press and hold the Valetbutton for more than 4 seconds,the car makes a tone and thefunction ends.Valet mode button formore than 4 secondsSimple tone sounds onceStep 4 ● Place the DIP switchto the OFF position ORclose the hood.Manual/AutomaticLoopDIPSwitchBecause the measured value is saved in the permanent memory of the unit, thetach setting is saved even if the power is removed.Note: Return the DIP switch to OFF after the setting.v4.2❃ Note Door pin switch (CON 7) must be connected.25