Responder LE Model 5701 Security and Remote Start Owner's Guide
Responder LE Model 5701 Security and Remote Start Owner's Guide
Responder LE Model 5701 Security and Remote Start Owner's Guide
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
utton: <strong>Remote</strong> Beeps234▀ Disarm <strong>LE</strong>D OFF: The remote will not emit beeps except when programming.A U X▀ Disarm <strong>LE</strong>D ON: The remote 5will emit beeps normally.▀ Disarm <strong>LE</strong>D blinking: The remote will emit beeps only for alarmtrigger messages from the alarm system.6button: Runtime Low Alert featureNote: This feature is not available on the 1-way remote.▀▀<strong>Remote</strong> <strong>Start</strong> <strong>LE</strong>D OFF: The remote will ignore Runtime Low Alertmessages.<strong>Remote</strong> <strong>Start</strong> <strong>LE</strong>D ON: The remote will emit feedback output forRuntime Low Alert messages.These messages will be automatically sent while <strong>Remote</strong> <strong>Start</strong> is ON toalert you when the runtime remaining is at 3 minutes, <strong>and</strong> again at 1minute before shut down.Note: This feature is not available on the 1-way remoteA U Xbutton: Page mode/Power saverNote: This feature is not available on the 1-way remote.▀ Aux <strong>LE</strong>D OFF: The remote will not wake up <strong>and</strong> listen for messagesfrom the system to extend battery life. Note: This means the remotewill not receive alarm trigger pages.▀ Aux <strong>LE</strong>D ON: the remote will wake up to listen for messages from thesystem▀ Aux <strong>LE</strong>D blinking: Power saver mode (see note below)Note: Power saver automatically turns off the remote pager if a buttonon the remote has not been pressed for more than 72 hours <strong>and</strong>will be restored after any button on the remote is pressed.12© 2008 Directed Electronics—all rights reserved
Change language