Manual - NEWPORT

OPERATIONNOTEUnplug any thermocouple probes from the thermocouple input sockets beforemaking any other types of measurements.Voltage Measurements1. Connect the red test lead to the "V " jack and the blacktest lead to the "COM" jack of the multimeter.2. For DC measurement, set the Function switch " V "position. For AC measurement, set the Function switch" V " position.3. Connect the other end of the test leads to the device orcircuit being measured.Current Measurements1. Set the Function switch anywhere from 430µA to 10Adepending on the range.2. In the 10A position, connect test leads to "A" and "COM"jacks. In lower ranges, connect test leads to "mAµA" &"COM" jacks.3. For AC measurement, press the button, and an ACicon will appear on the display.4. Connect the multimeter in Series with the circuit beingmeasured.Resistance & Continuity Measurements1. Set the Function switch to the resistance position.2. Remove power from the device or circuit under test.3. Connect the test lead to the "V " & "COM" jacks.4. The beeper sounds once, if the resistance beingmeasured is less than 30 Ohms.7