FAG tools for mechanical mounting and dismounting of rolling ...

CORPORACION BASCO SACAv. Argentina 1165 - LimaTelef.: 433-6633 / 433-6834 - Fax: 431-3188E-mail: ventas@basco.com.peFAG tools for dismounting of rolling bearingsHydraulic pressure tool 44 for small bearingsHydraulic FAG pressuretool 44ApplicationThe pressure tool is normally usedto loosen tightly fitted parts inconjunction with mechanicalextractors.Operation and handlingThe hydraulic pressure tool generatesan axial force of 80 or 150 kN, thusbringing about a significantreduction in the effort required.The spindle thread of themechanical extraction tool is notunduly stressed as the mainextraction force acts on staticthread flanks.The pressure tool PULLER44-150features a hydraulic returnmechanism, i.e. when the pressurescrew is reversed, the hydraulicsystem automatically returns to theinitial position.The hydraulic pressure tool isapplied between the shaft end andextractor spindle. The spindle isthen activated. The hydraulic systemis actuated by screwing in thepressure screw. The axial forcegenerated in this way loosens thepart. It can then be extracted in thenormal manner with the mechanicalspindle.For safety reasons, the minimumspindle diameter and the maximumtorque (see table) must beobserved.18Product range - hydraulic pressure tool 44Ordering designation Axial force Stroke Section SpindleTorque MassHydraulic height diametermax. Wpressure toolmin.kN mm mm mm Nm kgPULLER44-080 80 7 35 M22 25 0,6PULLER44-150 150 10 85 M30 50 1,74